2s Motor options?

[Ub Hauled]

email Brian:

[email protected]

[detox]

He answered in this tread...post #7. He is very difficult to reach sometimes, but here is his email address: [email protected]


...

[Jeff Wohlt]

How can the UL1 motor on 2s do anything? You have to have more KV

[raptor347]

Jeff's right, the UL-1 system is only going to work on 4S.

Nate, you have PM.

My rigger starts at $350 delivered as shown in the above pic (post 14) and goes up from there depending on what you want. It's also alot more boat than the Demon. It was designed for at least double the power. The red/white boat in the pic is my personal boat.

[nate]

Great Ok, whats the spec's, Hull length ect. Does it have a set of good setup directions?

I sent you a PM back Brian!

[nate]

I could just refer back to Darin's build.. sorry haha

[Ub Hauled]

How can the UL1 motor on 2s do anything? You have to have more KV

post edit...

[Ub Hauled]

Jeff's right, the UL-1 system is only going to work on 4S.

Nate, you have PM.

My rigger starts at $350 delivered as shown in the above pic (post 14) and goes up from there depending on what you want. It's also alot more boat than the Demon. It was designed for at least double the power. The red/white boat in the pic is my personal boat.

Brian, does your rigger come with hardware, turn fin/mount, booms, sponsons (glass)?

[nate]

I have asked these same question's, hold on for an answer UB.

[nate]

Brian has said this kit takes less for pin hole filling, He can explain, but It took me crazy hours getting my ptss21 ready for paint!

[raptor347]

Kit contains:
Tub, sponsons, hatches, rear shoe (all vacuum bagged epoxy glass).
Booms, turnfin and bracket, motor mount.

The front end comes set up. The shims are set to the proper starting angles and are adjustable. The turnfin installed and sharpened.

You get to install the motor mount, drive hardware and electronics. I put a veil cloth in the mold to minimise the pin holes and there are a couple tricks to quickly filling pin holes.

Anyone interested, send me an email and we can go from there.

[nate]

Kit contains:
Tub, sponsons, hatches, rear shoe (all vacuum bagged epoxy glass).
Booms, turnfin and bracket, motor mount.

The front end comes set up. The shims are set to the proper starting angles and are adjustable. The turnfin installed and sharpened.

You get to install the motor mount, drive hardware and electronics. I put a veil cloth in the mold to minimise the pin holes and there are a couple tricks to quickly filling pin holes.

Anyone interested, send me an email and we can go from there.

Brian, I don't remember you stating the length of you rigger kit? Thanks!

[raptor347]

29.5" without hardware.