Esc help

[twinnrigger]

TG Do they still make the Castle ICE 240 in the marine esc? and what do you think of the SF240.
Nick

[twinnrigger]

OK the ESC'S are shared with the 10s so what do you have in mind. After looking at the room i have i could stack the SF300 LITE in the rigger if this would be a good setup. Any thoughts ?
Thanks Nick

[RaceMechaniX]

Nick,

Castle no longer makes the Hydra ICE 240, they do make an Edge 240 or Edge 200 which can be used with pistol or stick radios.

However you are on the edge of what they will do. Really you need something bigger like the SF300.

[kfxguy]

Nick,

Castle no longer makes the Hydra ICE 240, they do make an Edge 240 or Edge 200 which can be used with pistol or stick radios.

However you are on the edge of what they will do. Really you need something bigger like the SF300.

What about the 280a mgms (28026) He was looking for something smaller. Now that we figured out (doh lol) that's he's not running 10 cells to each motor/esc his choices go up a bit.


Here's a link. I'd just get the lite versions.

https://www.mgm-controllers.com/race-boats/tmm-28026-3-for-race-boats-x2-series-lite.html

[kfxguy]

Or he could buy two mamba xl2's and swap circuit boards. (If his original controllers are the metal case ones like I'm thinking)

[dmitry100]

TG: Where do they sell the 240 Edge? I only see the 200 on their site.

What do you think are the best 6s controllers out there right now? (air or marine)

[twinnrigger]

Tyler do you think these SF300'S would be a good setup and would they need the spark capacitor pack with them ?
Thanks Nick

[twinnrigger]

Hi Guys, I did buy two of the sf300 lite and one pack of the 63v 5000 capacitor pack for the saw runs witch is recommended. i am going to use a 10s or 12s lipo battery shared with the two 1527 I/D Neu motors and the two sf300 lite. Can i get some help on how this should be wired with the shared battery?

Thanks Nick