I was just curious what is the minimum required Mah for running a AQ 2030 motor in my PTSS Hydro? For racing ovals 6 laps plus mill, etc...
I run a M440/3 blade or a D/T X442. Strut is approx. 3/4" deep or less.
I thought I saw Mike Ball or someone else run a pair of 2S 3700's in series at the 2014 nats. Is this enough?
I ask because I usually carry at least 6000Mah or recently 7600Mah but, I think it;s too heavy.
Advice, suggestions please?
I run a M440/3 blade or a D/T X442. Strut is approx. 3/4" deep or less.
I thought I saw Mike Ball or someone else run a pair of 2S 3700's in series at the 2014 nats. Is this enough?
I ask because I usually carry at least 6000Mah or recently 7600Mah but, I think it;s too heavy.
Advice, suggestions please?
Comment