Tweet
Hey,
I bought the Jet Sprint by Mickie Beez (http://www.offshoreelectrics.com/pro...od=mb-hull-610) off this site and built it as my first ever build. I have had other boats in the past but I thought it would be fun to build something that I could take on the river and now have to worry about tearing up my prop and let my nephew drive like a maniac. The build went fine enough but whenever I put it on the water it just skips. The jet will prime and then shoot it out of the water and then it will hit the water again and repeat. I just can't get it to run smooth no matter what I do. I run 2x8000mah 2s lipo's in series and I have tried them in the back of the boat, the front of the boat and every place in between but I still can't get it to run smooth to get any speed out of it.
Please help me figure out what I am doing wrong. Here is a pic of the inside of my hull, 2000kv leopard motor with a 180amp esc bought from offshore electrics.
20160716_190821.jpg
I bought the Jet Sprint by Mickie Beez (http://www.offshoreelectrics.com/pro...od=mb-hull-610) off this site and built it as my first ever build. I have had other boats in the past but I thought it would be fun to build something that I could take on the river and now have to worry about tearing up my prop and let my nephew drive like a maniac. The build went fine enough but whenever I put it on the water it just skips. The jet will prime and then shoot it out of the water and then it will hit the water again and repeat. I just can't get it to run smooth no matter what I do. I run 2x8000mah 2s lipo's in series and I have tried them in the back of the boat, the front of the boat and every place in between but I still can't get it to run smooth to get any speed out of it.
Please help me figure out what I am doing wrong. Here is a pic of the inside of my hull, 2000kv leopard motor with a 180amp esc bought from offshore electrics.
20160716_190821.jpg
Comment