Tweet
Probably thought i would never get the boat on the water, but tonight was the night.
uploading video as we speak.
the boat ran well and was dry inside. Ran one minute and checked temps, all were low, mid 80 to 100.
I removed the data logger and pulled the file, not sure if it is what i should expect but the rpm were lower than expected 17000 max. battery voltages were even with very little fluctuation. I did not get a amp report as I think i pulled the connector when I stuffed the logger in the pool noodle. Ran two runs with the only high er temps recorded with the temp gun at one of the motor connectors , 125f I think that connector fits looser than the others. Ill probably change it out.
the video say it will be at;
TRY THIS
AND THIS
I have not uploaded anything before so I may have to do it over.
If the RPM is only 17000 then the amps would seem like they should have been high and therefore hot. So I am not sure if 17000 loaded is ok or if it should be much higher which would mean that the radio was not going full throttle.
Also did not see any water spray from the exit ports, can the lines be hooked up incorrectly or???
overall a very successful first 1 minute then two minute runs just before dark.
This weekend I should give it a good workout.
uploading video as we speak.
the boat ran well and was dry inside. Ran one minute and checked temps, all were low, mid 80 to 100.
I removed the data logger and pulled the file, not sure if it is what i should expect but the rpm were lower than expected 17000 max. battery voltages were even with very little fluctuation. I did not get a amp report as I think i pulled the connector when I stuffed the logger in the pool noodle. Ran two runs with the only high er temps recorded with the temp gun at one of the motor connectors , 125f I think that connector fits looser than the others. Ill probably change it out.
the video say it will be at;
TRY THIS
AND THIS
I have not uploaded anything before so I may have to do it over.
If the RPM is only 17000 then the amps would seem like they should have been high and therefore hot. So I am not sure if 17000 loaded is ok or if it should be much higher which would mean that the radio was not going full throttle.
Also did not see any water spray from the exit ports, can the lines be hooked up incorrectly or???
overall a very successful first 1 minute then two minute runs just before dark.
This weekend I should give it a good workout.
I agree that your motor is NOT spinning @ a mere 17,000 rpm. I can tell that by the pitch of the motor.
Comment