MMProducts 39" Deep Vee

[jkr]

Alfa
Why you don't have it ready?
So much time passed and nothing.

[Heaving Earth]

This thread is about a beautiful deep vee with two Scorpion 3026 1400kV , 6S for each combo.

I get that part, but there's nothing here but a bunch of pictures of stuff over and over again.... Is this supposed to be a build thread?

[Heaving Earth]

Anyone notice this thread is exactly a year old today? A year!!!!

[JCAustralia]

Happy birthday : ) LOL.

[Heaving Earth]

Oops my bad it was a year on the 19th. Happy belated!

[Alfa Spirit]

Thank you, thank tou!

It take a long time because I have a job, my hobbies are not 100% model boats ,...
I changed 3 times the setup. First I wanted to use a CC 1717 but this (very good) motor have too much torque.I decided for a twin setup with FMT outrunners 1700kV . When Scorpion stopped 3026 series (now they are 3226) I had opportunity to buy a set of Scorpion 3026 1400kV, I installed FMT 1700kV in an other hull. Don' t worry about the Rapid, this hull is a real beauty, very good hardware including Speedmaster stingers, the HOR Racing one will be installed on the FOUNTAIN P1, this deep vee is 130cm long, 4092- 930kV motors and 10S for each motor

[Heaving Earth]

It's a great looking hull, be nice to see something done to it. It doesn't take more than 2 hours to mount some hardware....

[iamandrew]

Ill try and upload some pics of mine, i finally got around to some progress .
the main issue i had, was trying to find previous builds that were similar to what i wanted to do to the hull.
2 6S packs do not fit in the hull, unless you run the motor 5CM from the transom, and then have the packs in the middle of the hull.

[Heaving Earth]

Good idea drew. After 204 posts, it would be nice to see anyone post pics of one of these things getting built )

[iamandrew]

[Heaving Earth]

Interesting choice putting the rudder behind the prop

[Alfa Spirit]

Hi Andrew, you wanted to build a twin with Tenshock 2250 or it was somebody else? I send the master for the Rapid canopy, pdf file

[iamandrew]

well... not really Heaving, I looked it up on the net, and for some reason, every one ive found has the inline rudder. If it dosent go great, i can screw it into the other side and get it out about an inch to the starboard side. Bit worried to see how its going to go, that rudder hangs off the back ... a very far way!

http://www.offshore-rc.com/forum/uploads/post-1851-1276369530,6785_thumb.jpg

http://img194.imageshack.us/img194/6590/racemaster39.jpg

http://electricpowerboats.actie-forum.com/t678p60-mhz-racemaster-twin-bouwverslag

[Alfa Spirit]

With an inline rudder and a long bracket the boat turn very well with a twin setup or a single motor

[Rumdog]

Ok! Now drill!!!