MMProducts 39" Deep Vee

[Make-a-Wake]

Nice! Got any vid?

[Alfa Spirit]

No video that was my second build Graupner Arrow with a brushed Plettenberg motor and 20 elts Cad-Ni

Here are pictures of the MMP Rapid

[Alfa Spirit]

Any advice, What do you think?

[Make-a-Wake]

I would probably drill some holes and mount hardware at this time...............stickers look good.

[Alfa Spirit]

Yeah, it' s time to install motor, rudders, flex cable, stinger, etc..

What do you think about the look, too much or what?

[Make-a-Wake]

I like it, i just think your center stripe should have been orange like on the nose.

[jkr]

Just want to say this hull and the cc1717 is the ideal!
Nice stikers.
Probably lighter than paint!

[Alfa Spirit]

Yeah, it' s time to install motor, rudders, flex cable, stinger, etc..

What do you think about the look, too much or what?

I changed some details to have a better looking hull

[LarrysDrifter]

Do you buy hulls and put decals on to display them, or do you build the boat and use it? Its seems as if you are more concerned with decals and decal placement than building and running the boats. Why have a build thread if you dont build the boat?

[Alfa Spirit]

Don' t worry Larry

[cugino]

There is 4th page and no hole drilled yet :) A have to be more patient.

Good luck your build.

[Alfa Spirit]

RC Offshore MMP Rapid

Last version before clear coat UPOL#1

[Rocstar]

Seriously?

[iamandrew]

I still havent built mine either
need a new motor replacement, was going to use a 5692 1700 kv but its huge, i think a 4082 2000kv would be best

[Make-a-Wake]

I still havent built mine either
need a new motor replacement, was going to use a 5692 1700 kv but its huge, i think a 4082 2000kv would be best

Do NOT use a 5692..............I know why too , the 4082 is perfect for that hull.