Thundercat31 twin

[blackcat26]

Jeff are you saying to bring the stuffing tubes down thru the tunnel or out the transom behind the sponsons? My factory strut would be basically butted against the transom unless I made a extended mount for them.

[blackcat26]

Got a little work done this weekend. Holes plugged and transom filled and primed and got some under hull water pickups installed. Nothing that exciting yet.

[Jeff Wohlt]

Out each sponson

[blackcat26]

Thanks Jeff. I am still undecided.

[Jeff Wohlt]

With that hull you can do stingers and they are cheap. You do not need long ones. There are a bunch at HOR racing or other places. That hull has great room for a twin set up.

[blackcat26]

I think I will stinger it Jeff. Maybe the ones Kintec Racing. Would the bearing ones yeild higher speeds?

[blackcat26]

Slapped some primer down and installed the servo mount tonight. Pretty boring stuff hang in there.....

[timjz]

Where did yo get the servo mounts from? They look pretty nice!

[blackcat26]

It's the one they sell on here. Very good quality and pretty sturdy once tacked down.

[blackcat26]

Got my motors in. Going with the Scorpion 3026-1600kv for sure. Waiting on stingers for Kintec and got the bottom painted. Used ace hardware appliance epoxy. Went on great and looks good. Well It would look better if I would have sanded the primer a little better.

[forescott]

Is that just a gloss white? I got a can of appliance epoxy for the inside of the hull, but if you think the finish looks nice I'd like to try it on the outside as well.

[blackcat26]

It is a hard finish also. Dries fast and looks good. Yeah its gloss white.

[blackcat26]

Got one stinger in. The other one is backordered......Figures

[blackcat26]

Hull and hardware is up for sale in the swap shop!