The new rudder setup and transom repair went just fine..............just got back from a 2/3 throttle run...........thank goodness thats all i did because i put fresh batts in the TX and i have realized that the servo is the culprit
.............it randomly changes its centerpoint, so i have to over compensate for it, then it goes back to the old centerpoint...........overcompensate the other way................what the H......???? Its going in the trash. Thats why i crashed the other day..............freakin zig zaggin all over
I didnt have my temp gun after i got it in, but i could hold my finger on the wire end of the endbell for 5 seconds..............that should be good i imagine.
.............it randomly changes its centerpoint, so i have to over compensate for it, then it goes back to the old centerpoint...........overcompensate the other way................what the H......???? Its going in the trash. Thats why i crashed the other day..............freakin zig zaggin all over
I didnt have my temp gun after i got it in, but i could hold my finger on the wire end of the endbell for 5 seconds..............that should be good i imagine.
I have heard that 2.4ghz radios dont like sudden voltage drops...............could be true. Ran very nicely..........now that everything is "ready" i can vid on Sunday.
Comment