WTB. Neu 1527 or castle 1717

[atechbh]

From that motor to 1/4 inch drive cable.

[ray schrauwen]

I don't know if that even exists... I have a 6mm to 1/4" but, I'll need that...

Motor has a 5mm shaft. If I had time I'd lathe you one up but, I'm pretty busy!

[ray schrauwen]

Here is one of he only places I know of that makes a 5mm to 1/4" shaft. Best collets made!! http://www.rocketcityracing.com/MBP-...63_p_1714.html

[atechbh]

I will verify the size of driveshaft. Is motor shaft 5 mm?

[ray schrauwen]

Yes motor shaft is 5mm.

[ray schrauwen]

Got payment but, Paypal says to wait to ship until payment is cleared within 24 ours or less. I will keep you posted and ship accordingly.

Thank you!

[atechbh]

Did you have a motor mount for it ? Or what one would you recommend ?

[ray schrauwen]

No motor mount here but, what is it going into?? HRC or Fightercat may have one... I haven't checked OSE or Keith Bradley boats dot com.

[atechbh]

It's going into a team believer 36 by areomarine

[ray schrauwen]

I just checked, Fightercat sells one for $45 + shipping. Says they have some left. To see their product, you have to sign up with usename + password then you can see the products and prices. You should email them first and confirm what they charge for shipping to Canada.

You will have much fun with that hull & motor, nice combination.

[ray schrauwen]

CNC Rail Mount with 4" rails for 1717, 1520 + Other Motors ........ http://fightercatracing.com/

you could use one of these but, it would still need some rear support IMO... http://www.offshoreelectrics.com/pro...prod=ose-80902