WTB rudder/strut assembly

[masonis1]

I need a rudder and strut around 75mm to 110mm with an adjustable strut. Pm with detail on what you have.

[izcain]

I have a rudder and strut assy. off of my daytona I would let go. I want to get rid of the whole setup. .150 cable with 3/16's prop shaft and adjustable strut and rudder with breakaway bolt. Someone sharpened the rudder and strut and made it really sharp. I just upgraded to one of OSE's other setups. How much were you wanting to spend? I believe this one is 110mm

[izcain]

I have another new 1/4 inch stuffing tube as well to go with the setup someone would just need to get a teflon liner to make it all work together again.

[masonis1]

I have found one on ebay for 20 bucks but was told the 1/4 inches shaft size was overkill for my boat. How much were you wanting for EVERYTHING? I need flex line and adapters too if you have any?

[izcain]

I have a spare collet that would work but like I said the only thing you would need would be a teflon liner.

[masonis1]

Im new and i dont even know what the teflon liner is... Hah how much for everything?

[izcain]

35 shipped as long as you are in the 48 states.

I also found a teflon liner I Will include. So this is everything to put a drive setup on your boat. They go for over 60 new.

This is not a cheap ebay setup. It is a OSE setup just a previous version. It also has the cooling pickup in the rudder as well.

Whats your e-mail and I can send you some pics if you want. Or you can look here http://www.offshoreelectrics.com/pro...prod=ose-80085 and it is pretty much the same setup just an earlier version.

[masonis1]

My email is
[email protected]
Send some pics my way and i will take a look.

[izcain]

pictures should be in your mailbox

[masonis1]

I will take a look. Thanks

[masonis1]

Everything looks good. So i can get my boat running with all this correct? I have motor, esc, reciever, battery, all i need is this then cprrect?

[izcain]

Youll need a rudder servo and a way to link it to the rudder. I would suggest browsing the "how to" on forming the stuffing tube. There is a lot of helpful hints in there.

[izcain]

What kinda hull is this going into?

[masonis1]

I have the servo. So i would have everytjing with this to get a prop turning and steering correct?

[izcain]

You will need a prop also but that will depend on what hull and motor/esc/ect combo but yes this should give you steering and a way to transmit power from your motor to a prop.