WTB 5692-98 1000kv up to 1200kv Motor and 2100mah lipo/ life receiver pack

[Drax21]

OK, this corrects my previous thread. Looking for a motor in the range as suggested above. New or slightly used.(10 runs or less)
and a 2100mah lipo or life Receiver pack. I don't want to place an order with HK for one item so checking on here!

Let me know if you can help.
Thanks

[Drax21]

HK 5692 1000kv would be great. New or used.

[m4a1usr]

HK 5692 1000kv would be great. New or used.

I have a Leo 5692 in 1090kv available. New. Never used. Project went another direction. $125 shipped Ooooooooor,........I also have a new Top Power 5692 (rebranded Leo) for $115 shipped. It says 1060kv on the side.

John

[Drax21]

I have a Leo 5692 in 1090kv available. New. Never used. Project went another direction. $125 shipped Ooooooooor,........I also have a new Top Power 5692 (rebranded Leo) for $115 shipped. It says 1060kv on the side.

John

Hi John, thanks for the reply. I would love that Leopard but I have bought a FC 16s 200amp esc and now I see on the FC website that there has been intermittent probs reported by some people. I have sent Ben a few questions as to what voltage/kv the problems occurred on. Maybe it differs. What shaft sizes are they anyway?

Thanks
Tim

[m4a1usr]

Both motors have a 5mm shaft. I have lots of Octura couplers already so I bought the motors to use my current inventory. Forgot to mention. Leo water jacket comes with either motor.

John

[Drax21]

Both motors have a 5mm shaft. I have lots of Octura couplers already so I bought the motors to use my current inventory. Forgot to mention. Leo water jacket comes with either motor.

John

I will have to pass. 5mm is a bit too small for me and a 1/4 cable. Thanks Anyway

[Brushless55]

Hi John, thanks for the reply. I would love that Leopard but I have bought a FC 16s 200amp esc and now I see on the FC website that there has been intermittent probs reported by some people. I have sent Ben a few questions as to what voltage/kv the problems occurred on. Maybe it differs. What shaft sizes are they anyway?

Thanks
Tim

What are the issues that you have read about ?
thanks

[Drax21]

What are the issues that you have read about ?
thanks

I am just going by this message on the FC website product page.

Some issues have been reported with high pole outrunners intermittently, also with Leopard 56 series motors... Runs very well with Lehner motors and 40mm 4 pole motors.

[Brushless55]

Thank you..
I thought maybe there were issues with the motor..
but the esc has issues running some Leopard motors..

[Drax21]

Still looking. 6 or 8mm shaft please. 8 preferable