WTT For a 540 7S, 5L or Similar 2s Motor

[Meniscus]

I'm looking to trade the following:

Feigao 380 7S 5639kv - maybe one run
Feigao 380 8L 3613kv - 2 runs
Mile High RC 400f 2250kv - 4-5 runs
- I have 1 water jacket and 1 silicon jacket for the 380 motors.

Looking for a 540 size (36mm diameter) 2s motor in good condition, no play in bearings. I'd consider short or long cans, say something similar to a 7S or 5L.

Let me know what you have and please include kv.


Thanks.

[Meniscus]

No takers? Please note that I'm looking to trade all 3 motors for the one 2s motor.

Let me know what you have and perhaps there's a match. Thanks.

[Meniscus]

Still looking. Let me know what you've got.

[Alexgar]

I have a 540s 3400 that I'll trade for the 380 motors

[Meniscus]

Thanks, but I'm looking for at least 4700-4800kv. Do you have anything with higher kv?

[Alexgar]

I have a excelorin 4800 it has a stepped down shaft 5 mm down ti 1/8 it broke at the step but there's enough of the 5pm part to put a collet on and the bearing were replace by me works fine just to many amps for the batteries I use rather run 4s than 2s2p lmk I'll send a pic

[Meniscus]

Do you have a link to specs? I don't keep track of all the motors available in the marketplace. Please forgive my unfamiliarity.

[Alexgar]

It's at horizon it's a 540s sized motor 4800 kv it doesn't say amp consumtion but I've run it on a Trx vxl and the Losi esc that came with it they were both about 100 amp escs and never broke a sweat

[Meniscus]

Please post a picture and let me know what gauge wires it features. That's usually a good indicator of how many amps it will handle.

Is this sensorless or sensored? Also need to know how much of the 5mm portion of the shaft is left.

Is this the manual? http://www.horizonhobby.com/ProdInfo...otorManual.pdf

Thanks.

[Alexgar]

I'll post a pic tomm I'll use my caliper to measure all specs it holds a collet it doesn't have wires it has solder tabs at one time I soldered 12g but now it has 3.5s males soldered to the tabs

[Alexgar]

Collet fits but don't think it will take a thrust bearing due to the short length

[Meniscus]

No problem. If I understand correctly, it has ball bearings and an endbell that is held in place by screws. The thrust bearing isn't mandatory.

[Meniscus]

Constant Amps, 69A. If she handles a peak of 700 for instance, then that would be 97A. It's very close to the edge on my setups, but may be feasible.

When you put a caliper on the shaft, please also check the can size. I'd like to know if I can run a water jacket. That will mean the difference.

By chance, do you have anything with a higher KV as well? Perhaps we can work out a cash deal in addition.

Thanks!

[Alexgar]

motor spces

36mm wide 52 mm long 5mm shaft that 8 mm long

[Alexgar]

I'll throw in a Jeff shoot collet thats 5mmx.150 it's missing some set screws I took for another project