HOR Prince driveline and hatch needed

[Skipster]

All parts found.
Thanks guys!!

I bought a HOR Prince mono
same boat as Kintek or Engage Rocket

It came without flex shaft or strut drive shaft and bushings.
This is the 4mm square ended setup.

I am only sporting this boat so I do not want
to upgrade to the 3/16 setup.

I am hoping someone might have their old setup
leftover after moving on to the 3/16 flex ect.

I also need a hatch if someone has one.

Thanks for any consideration.
Skip

[ENCORE MAN]

Skip, Neal in our park junked this setup and went to 3/16, check with him. BG

[Skipster]

Thanks BG, will do.

[6S HYDRO]

I have the hatch, yellow skunkworks/prince

[tunnelvision]

If you still are looking for the flex, I have the 4mm setup. 1/8th to 4mm collet, flex shaft, strut, drive shaft/drive dog, bullet prop nut, and I think I still have the copper 35mm prop too. Let me know what you want and we can work something out.

[tunnelvision]

Got a pic of the stuff I have too. I have 2 collets actually. 5mm to 4mm and 1/8th to 4mm. Also have the stock copper prop, 3 graupner cf props (36mm x3, 37mm x 2, 39mm x 2) and complete strut and bracket. Still looking for my bullet nut.

[Skipster]

quick note to say
"Thanks guys"

PMs away, we'll get this baby wet yet!

Best Rgrds,
Skip