Wanted: 3.2mm to 2.3mm coupler

[befu]

The 6-32 wasn't a quantity, it's the size. Quantity was four - 2 on each end drilled through. And that is a good arrangement. You'll want at least 2 screws on each end to be able to balance the coupler to minimize vibration. I usually ask for three (spaced 120 degrees apart) when the application is a jet drive. Jeff Wohlt does a bangup job on these, I've had several made up for me in the past.

Yeah, that requires me to actually lift my rotary table up and bolt it down - lots of work there for a free coupler!

Yeah, 6-32, 6-33, whatever it takes....

Brian

[bustitup]

Yeah, that requires me to actually lift my rotary table up and bolt it down - lots of work there for a free coupler!

Yeah, 6-32, 6-33, whatever it takes....

Brian

yes sundog makes sense 2 on each end sounds fine

befu I wasn't expecting it to be free...thanks so much for the gesture and effort

[befu]

yes sundog makes sense 2 on each end sounds fine

befu I wasn't expecting it to be free...thanks so much for the gesture and effort

Shoot me your address, it will mail out tomorrow. That is the second time I needed a 2.3mm drill bit so I ordered one, will be in tomorrow. The rest of it is done but I need to drill it out the last .002" for 2.3mm. Hopefully it will work, when I make them I usually have the shaft and motor here to trial fit them. The one I made for my mini hydro I just used a .093 bit, but it felt loose.

Let me know how you like that motor. I have the 2350kv version in my 1/16 hydro and it seems to work well.

Brian

[bustitup]

I received the coupler from befu about a week ago and worked absolutley perfect.....very nicely done

thanks befu

[befu]

I received the coupler from befu about a week ago and worked absolutley perfect.....very nicely done

thanks befu

Your welcome.

Glad it worked out, Brian