Just sent my $140 in from [email protected]. I put a note in there stating I will take the BEC if it will handle 6S and if not, to just send me the standard unit. Should I go with the caps for a 6S application as well? Thank you.
Joe
I'd use it on any higher amp application where there is a long wire (over 7")
:::::::::::::::. It's NEVER fast enough! .:::::::::::::::
Just sent my $140 in from [email protected]. I put a note in there stating I will take the BEC if it will handle 6S and if not, to just send me the standard unit. Should I go with the caps for a 6S application as well? Thank you.
Joe
Bec is good to 5s. I will send the esc with NO bec. As Ub said about the cap bank. Let me know either way on the cp bank. Esc will not ship until I hear one way or the other.
Bec is good to 5s. I will send the esc with NO bec. As Ub said about the cap bank. Let me know either way on the cp bank. Esc will not ship until I hear one way or the other.
If you recommend the cap bank for a 6S Feigao 12xl setup, then I'll take that too. I just honestly don't know what the advantage to using them is. Help prevent ESC voltage from dropping too low under quick load? Thanks.
Joe
I am only 6" from the battery to the ESC- but the one wire that connects the two packs as a series is ~8 1/2" (3" on each pack and about 2.5" on the "y" connector.
I am only 6" from the battery to the ESC- but the one wire that connects the two packs as a series is ~8 1/2" (3" on each pack and about 2.5" on the "y" connector.
Should I use the caps or no?
Its added insurance against lows in voltage. Let me know either way so I can ship this out.
Tweet
Comment