Want to Buy HPR 06 115cm hull any condition

[justintime2w8]

I am looking for an hpr hull, the 115cm one. Let me know what you have.
Thanks,
Justin

[justintime2w8]

never mind

Just ordered one new from Hanspeter so I am covered, Thanks

[lomdel]

Just ordered one new from Hanspeter so I am covered, Thanks

Who is Hanspeter Justin, from SwissModelPowerBoatClub or where? What did you pay for it (PM me if you don't want to mention it here). And most importantly, what set-up you plan to run in it?

[lomdel]

Thanx for the PM. You must be extremely excited about this purchase!! I would be. Please post pics of the package upon arrival and the unboxing, if possible. I would like to see how they packaged it. We look forward to a build thread as well.

"I will run twin either lmt 2250/5t or neu 1527/1d on 6s 2p each side. I will most likely get a pair of non-hv hydra 240's" You sure 6S2P each side won't be too much?

[justintime2w8]

Yea I am excited, I like the idea of a heavier boat. Another guy in the US has run the 6s2p setup and gets tons of runtime and so far a top speed of 75mph. It is my understanding that with the smaller motor 1p setups you have to add weight to the boat anyway.

[lomdel]

So you are going to run 6Sx2=12 lipo cells each side that is 24 lipo cells! Lot of power there mate...

[justintime2w8]

Well it may just be 6s1p to start and I may still go with 1521's or 2240's. It will be a bit before I have to make that choice. I do want it to be a fun boat too. I just looked again and I think that guy had the 135cm hull so mine will most likely be 6s1p a side. It seems these hulls run quick with just about any twin setup. You could get well over 60mph with a pair of feigaos.

[lomdel]

...You could get well over 60mph with a pair of feigaos.

Which Feigaos on 6S1P. 13XL?

[justintime2w8]

I think I would go 10-11xl, but I would not use them, I like the neu's and lehners even though they are a bit more. Well, ok, like 3x more.