Drifter S National SAW Record Holder for Sale

[properchopper]

Drfsideview320190609_150256.jpg DrfIntUse20190610_114004.jpg

Drfbot20190609_144849.jpg Drfrudder20190609_143925.jpg

DrfRudFlipPlusAcc20190610_125413_resized.jpg

https://www.youtube.com/watch?v=ZazuhcWy-Kc

Hydro and Marine Drifter S - Current P-Ltd Cat Straightline Time Trial (SAW) NAMBA National Record Holder 67.771 mph 2-way average on 4S with factory stock AQ 2030 up for sale now that NAMBA SAWs have left California.

Made in Germany H & M Drifter-S hull (25-7/8 ? + hardware - full length 29-7/8?)
AQ 2030 with water jacket - used but not abused
Fightercat 140 amp ESC + programming box
Offna rudder servo
.150 flexshaft
Generic strut w. inline rudder (configured for quick flip-up to facilitate removing & lubing flexshaft + offset rudder adaptor bracket & offset rudder servo rod)

The hull has never been crashed into anything but has a number of frequent flier miles. It has expandable foam in the nose, glassed interior hull side seams and has had several gelcoat hairline cracks and noticeable but solid hull seams repaired. The hull IS extremely strong/solid. Originally yellow in color, the paint job isn?t shiny/flashy highly detailed and honestly could use some new paint. It?s a raceboat paint job and gets the job done.

Drifter hulls are a true stepped design and air out to the point of basically flying over the water leaving almost no wake. (pictures available)

With a fresh set of Dinogy 3800?s set up for P-Ltd. with the AQ2030 it has made several verified/witnessed one-way fast passes over 70 mph.

Can be operated with 2 X 2S 5000?s in series or 4S2P 3600 ? 3800 ? 4000?s.

The ESC is robust, and has one unique operating procedure in which it waits 10 seconds after powering up to check itself ( full throttle position) before each arming. Includes a Fightercat dedicated program box.

For Sale for $295 plus shipping ? Add your radio, prop and batteries and rock & roll
(rx in picture only to show suggested mounting location)

will estimate shipping with zipcode- CONUS please ? Paypal

All OSE For Sale rules observed - will gladly answer questions or provide more pictures if needed

Thanks for looking,
Tony
[email protected]

[Brushless55]

Is this hull any good at oval racing?

[properchopper]

Is this hull any good at oval racing?

I never tried it, but while it would eat alive the Geicos & MC's in the straights it would have a tough time cornering in racewater where the aformentioned bigger hulls would have a better chance.

[Brushless55]

I never tried it, but while it would eat alive the Geicos & MC's in the straights it would have a tough time cornering in racewater where the aformentioned bigger hulls would have a better chance.

Thanks Tony

[properchopper]

Price drastically lowered - buy it now !!

I need the room (and some project money )

$ 225 SHIPPED CONUS PP

prior to re-paint - fully aired out

drifter aired out 10.jpg

[donhuff]

Tony,

How much if you keep the RX and ESC, if you are OK with piecing it out. I have my own and that ESC probably wont hold up to my motors anyway.

[properchopper]

Hi Don,

I'll go $175 without the ESC & prgrm box - the rx was just for the picture [ from post #1: For Sale for $295 plus shipping – Add your radio, prop and batteries and rock & roll]
(rx in picture only to show suggested mounting location)

[donhuff]

OK i'll take it. when you figure out the shipping, get back to me.

[properchopper]

In its foam coccoon at the shipper

ship drftr 20200311_143112_resized.jpg