32" Carbon fiber fightercat rivercat

[Vin-m]

Here is a 32" cf fighter cat rivercat. It has been enlayed w/ cf and has cf plate reinforcing in the transom and rudder area. It also comes w/ cf motor mounts that are drilled for 36sized and 28sized motors. The hull is not drilled and is like new.
$260 shipped in the lower 48
20181030_154838.jpg20181030_154808.jpg20181030_154946.jpg20181030_155155.jpg20181030_154959.jpg

[Vin-m]

Bump

[lt130th]

What drives are typically used for these hulls?

ose-80105.jpg 110mm versions for 3/16" prop shaft, or something shorter?

[Vin-m]

I would use the 80mm version of those.

[lt130th]

I would use the 80mm version of those.

The 80mm ones for 4mm prop shafts? Can you post a sketch of one of the transom footprints, with dimensions, or some pic's with a ruler? I already have a pair of stingers and I'm wondering if there's enough room for them to bolt on and still be adjustable. It might be useful info to any potential buyers besides myself.

Thanks,
Michael P.

[Vin-m]

Yes the 80mm w 4mm shafts. If you look 2 post below this one on the forsale page I sold a built boat with the stingers were talking about and there is some pictures to give you an idea. I'll be home Saturday and I can get you some measurements then if you want?

[lt130th]

I'll be home Saturday and I can get you some measurements then if you want?

No rush. If you remember Saturday, that'd be cool.

[Vin-m]

Yup np. I'll post em in the morning on sat

[Vin-m]

20181110_083544.jpg20181110_083702.jpg20181110_083712.jpg

[lt130th]

Hey, thanks! Looks like my stingers will fit that. I'm trying to finish up some other builds and thin the fleet, actually, so I'll focus on that for now. I'll keep my eye on this one, though.

[old guy]

you have been paid thanks

[Vin-m]

Sold pending payment

[Vin-m]

Sold