ARTR Lizard Xtreme C-AFK Everything Accept Transmitter - Ran One Time

[Finest Racing]

ARTR Lizard Xtreme C-AFK
The decals are water base. They can be removed very easily.
I built this boat for my son and I to race in NAMBA. After completing the boat my son lost interest and we started flying planes.
My son and I took the boat to the lake to check our build. It worked great. It was in the water for about 2 to 3 minutes. We ran the boat on 4s in parallel.

All you will need is a transmitter to have fun.

PLEASE: NO TRADES OR PARTING OUT. I am selling the boat complete.
Asking $1,000.
Shipping will be calculated for the destination.
I am located in Central New Jersey (USA).

The Official Seal is located inside the boat. Picture below with seal.
Material: C-AFK
Color: Red
Length: 830mm (32,66")
Width: 240mm (9,44")

Assembled:
Lizard C-AFK - 1717/N-C-AFK
Fit out set carbon Lizard Xtreme -
ESC Mount
NEU 1527 5Y 2500KV 5mm shaft
Flex shaft -
Silicon hose
Water outlet
Battery Trays - Both sides
Traxxas 2075 Steering Servo
Spektrum MR200 Receiver
Hobbywing 180a ESC
MBP Collet 5mm
Water sealed rubber cuff
MTC Rudder - Strut combination with integrated water inlet

Lizard 01.jpgLizard 02.jpgLizard 03.jpgLizard 05.jpgLizard 06.jpg

[Finest Racing]

Lizard 07.jpgLizard 08.jpg

[TRUCKPULL]

What ESC is in it?
Why a 8mm collet with a 5mm motor shaft?

2500 Kv motor - how many cell did you run and what size prop?

Larry

[Finest Racing]

My mistake for the collet. I have a 5mm collet on the boat. I ran two 4s packs - parallel. The ESC is a Hobbywing 180a. The prop I used was a 442.

[Finest Racing]

Bump