32" skunkwork catamaran clone with pvc stand and hardware for build

[Jcarlton]

new hull , new aluminum servo mount , new 3/16 drive shaft with stuffing tube , aeromarine stuffing tube seal with oiler , new aluminum thru hull water line fitting and exit , new kintec aluminum exhaust tips , 2 new collets , 2 new bullet prop nuts , new 3/16 strut and rudder . ( drive shaft and servo mount are not pictured but included )

$200 shipped

dt5.jpgdt4.jpgdt3.jpgdt2.jpgdt1.jpg

[Jcarlton]

dt9.jpgdt8.jpgdt7.jpg

[Jcarlton]

ttt offers ?

[Jcarlton]

ttt

[Jcarlton]

ttt

[MG1234]

How wide is your hull ,looking for one to replace a genesis,thanks,

[Jcarlton]

9 and 1/2 inches

[MG1234]

Thanks I’ll compare to my others and get back to you ,

[MG1234]

That’s same as a genesis just 6” shorter, a little on the skinny side ,I’ll go 150$ shipped to 92251 ,let me know ,thanks ,

[Jcarlton]

Shipping is gonna be over $40 ... against my better judgment I could go $180 ... if your ok with that lemme know .

[MG1234]

How about we split it at 175$ ?

[Jcarlton]

deleted

[Jcarlton]

just noticed you are in california ... shipping calculator shows ruff estimate cost of $59.64 to ship usps ground .... have over $300 invested . i cant take that much of a loss .

[MG1234]

That ok,I understand,thanks anyway ,

[Jcarlton]

ttt