Sold and shipped - sort of. He's just getting started and through PM we determined another boat I was going to list was a better fit for his intentions. Leaving this one up for another week before I part it out.
Another of my early builds modified slightly from Dave Frank Oberto plans. Offset ride pads again. Balsa and thin ply with CF for strength. 27-1/4" long, 13-1/2" wide, with the tunnel at 7-1/2". Hatch opening is nearly 4". Weighs in at 1lb-15oz as pictured with Hitec 85MG servo, Solinger hydro hardware set and .130 hughey shaft for 3/16" props. AQ hydro turn fin and bracket on this one. Good runner with the brushed LTD setup of years ago. Need to clear off some shelf space since I can't break the habit of building more boats. $75 OBO shipped in the lower 48. Outside the states possible by covering difference in postage.
Another of my early builds modified slightly from Dave Frank Oberto plans. Offset ride pads again. Balsa and thin ply with CF for strength. 27-1/4" long, 13-1/2" wide, with the tunnel at 7-1/2". Hatch opening is nearly 4". Weighs in at 1lb-15oz as pictured with Hitec 85MG servo, Solinger hydro hardware set and .130 hughey shaft for 3/16" props. AQ hydro turn fin and bracket on this one. Good runner with the brushed LTD setup of years ago. Need to clear off some shelf space since I can't break the habit of building more boats. $75 OBO shipped in the lower 48. Outside the states possible by covering difference in postage.
Comment