Needing to clear out some shelf space. Starting off with a scratch built Wildthing mono. Altered the original plans to make this 33.5" long and 10.75" wide. Pink Styrofoam was fitted in the front third of the hull. Remainder is coated in carbon fiber. Motor mount fits a Neu 1521. Servo is Hitec 645MG. Speedmaster hardware with 3/16 flex. Flooded shaft setup allows for easy height adjustment. Hatch is ply with pink foam upper covered in fiberglass. Very solid boat that comes in just under 4 lbs as pictured. Small bit of road rash on the right front as pictured. Had one ESC give out in it and couldn't quite get the smell out - not that noticeable. Plenty of room for 2 - 4s packs for Offshore style heats. Decals are printed water slide decals sealed with clear. Scuff them with sandpaper and they should wash right off. $130 shipped in the lower 48. Can consider outside the states with postage adjustments. Post questions here - follow forum rules.
20180106_141931.jpg20180106_141949.jpg20180106_142024.jpg20180106_142047.jpg20180106_142127.jpg
Adding on a couple extras. Extra 3/16 flex that can be cut as a replacement. Drive dog, and your choice of a 5mm or 8mm to 3/16 coupler. Pic below.
20180106_141931.jpg20180106_141949.jpg20180106_142024.jpg20180106_142047.jpg20180106_142127.jpg
Adding on a couple extras. Extra 3/16 flex that can be cut as a replacement. Drive dog, and your choice of a 5mm or 8mm to 3/16 coupler. Pic below.
Comment