Tweet
Again another hard decision as this was my first real build from an old hull.
Fine Design Offshore Deep-V, 32" long, hull is ABS, but very thick, it is not flimsy
Motor: Leopard 4082 - 1450kv with Custom Fiberglass Rails
ESC: Seaking T180 V3 (with extra cooling loop)
Servo: Airtronics metal gear and ball bearings (has been waterproofed)
Tx/Rx: Traxxas TQ (Rx waterproof with Traxxas waterproof case)
TFL motor coupler (5mm to .187 - 3/16" cable)
(2) OSE .187 - 3/16" flex cable
ProBoat Strut
ProBoat Rudder
TFL Turn fins
FDM Trim Tabs
Custom Servo Mount
Kintec water lines (dual pickups)
M3 stainless hardware throughout
M3 stainless hatch hold down
Boat is capable of 50+ mph and runs good with 42-45mm props. Cooling works well, I have datalogs if you are interested in seeing any information on the setup. It's never been flipped or dunked in any way.
Asking $600 plus shipping (estimate $50 lower 48)
Add EagleTree V4 datalogger with all sensors for $100
Add (4) 6s Zippy Compact 5000mah packs for $160 (less than 20 runs, good IR measurements)
Build log for reference:
https://forums.offshoreelectrics.com...d-Build-Advice
Running Video in the past few weeks:
20160724_220344.jpg
20160724_220350.jpg
20160724_220358.jpg
20160724_220451.jpg
20160724_220457.jpg
Fine Design Offshore Deep-V, 32" long, hull is ABS, but very thick, it is not flimsy
Motor: Leopard 4082 - 1450kv with Custom Fiberglass Rails
ESC: Seaking T180 V3 (with extra cooling loop)
Servo: Airtronics metal gear and ball bearings (has been waterproofed)
Tx/Rx: Traxxas TQ (Rx waterproof with Traxxas waterproof case)
TFL motor coupler (5mm to .187 - 3/16" cable)
(2) OSE .187 - 3/16" flex cable
ProBoat Strut
ProBoat Rudder
TFL Turn fins
FDM Trim Tabs
Custom Servo Mount
Kintec water lines (dual pickups)
M3 stainless hardware throughout
M3 stainless hatch hold down
Boat is capable of 50+ mph and runs good with 42-45mm props. Cooling works well, I have datalogs if you are interested in seeing any information on the setup. It's never been flipped or dunked in any way.
Asking $600 plus shipping (estimate $50 lower 48)
Add EagleTree V4 datalogger with all sensors for $100
Add (4) 6s Zippy Compact 5000mah packs for $160 (less than 20 runs, good IR measurements)
Build log for reference:
https://forums.offshoreelectrics.com...d-Build-Advice
Running Video in the past few weeks:
20160724_220344.jpg
20160724_220350.jpg
20160724_220358.jpg
20160724_220451.jpg
20160724_220457.jpg
Comment