Lehner LMT 2260LK 8 Wind (1233kv) 8mm with Cooling Can

[c_michael_72]

This is a gently used Lehner motor that was purchased from KBB. I was told that it was in a twin for approximately 10 runs before I purchased it. I bought both motors for $875. Since I purchased it, the only thing that has been done is that the bullets were changed from 6.5 to 6mm. It has not been installed since I purchased it. I'm keeping one of the motors and selling this one for $350 including shipping to the lower 48. Price is solid, thanks!

[c_michael_72]

lowering price from 425 to 400

[don ferrette]

Go $375 shipped and I'll take it.

[c_michael_72]

@ Don - will pass on $375...thanks for the offer.

[don ferrette]

@ Don - will pass on $375...thanks for the offer.

All good, things are just tight for me these days.

[c_michael_72]

I understand. I found a few 8mm / 3/16" MBP collets (new). I can throw one of those in if it helps. Will post a pic.

[don ferrette]

I understand. I found a few 8mm / 3/16" MBP collets (new). I can throw one of those in if it helps. Will post a pic.

Actually I would run 1/4" cable step to 3/16" on what I would use it for.

[c_michael_72]

I will check and see if I have an 8mm / 1/4...I might but don't think it would be MBP.

[c_michael_72]

Sorry for the late response, I didn't have any 1/4" collets.

Motor is still available as advertised.

[don ferrette]

Sorry for the late response, I didn't have any 1/4" collets.

Motor is still available as advertised.

My offer still stands as well if you change your mind.

[c_michael_72]

Thanks again for the offer.

[c_michael_72]

bump

[c_michael_72]

and again with a bump...

[c_michael_72]

still available

[c_michael_72]

bump