FOR SALE- 10S rigger race ready

[don ferrette]

I have decided (reluctantly) to put my 10S rigger up for sale. This is my take on what an FE Crapshooter would be if Stu Barr offered them (he doesn't and won't). Extremely fast and stable, corners like it's on rails and can live in lane one all day long including the turns. There are a few here on OSE who can vouch for how ballistic the boat is, it has not lost a race yet. This is the very same boat (with a hotter motor) that held both the 1/4 and 1/3 mile IMPBA oval records up until last fall and is not for the faint of heart. To be sold turn key (except TX) right down to the prop I heat race it with. Powered by a NEU 1530 (8mm shaft) and a Castle 200HV ESC featuring cooling conversion by Mike Luszcz (developed by Brian Buaas). This ESC has performed flawlessly this way (as do all my other Castles featuring same conversion). Two Giant Power 5S 65/130C 5000mah packs provide the power, Futaba 603FS FASST RX, Futaba 9405 servo for steering, 2700mah 6V RX batt pack, CastleLink for data logging. SpeedMaster hardware with Steve Woods rudder blade and Tyndall Turn fin, Prather stainless prop. Paint is top line PPG acrylic urethane. $1800 shipped and insured in the continental U.S. (international extra shipping).

SOLD pending payment

[nmnorth]

Hey Don , how wide is the tub where the batteries go

[photohoward1]

I bet you could fit 4x5s 3300 up front.

[nmnorth]

thats why i asked my question of width

[don ferrette]

Hey Don , how wide is the tub where the batteries go

Hey Bill, tub inside width is 4". I never had any issues getting it done on 5000mah. One mill lap, 6 race laps, park it in the infield until everyone else finished and then come in. Personally I would prefer 2 packs vs. 4 for less connections, means less total resistance.

[nmnorth]

ok Don , also what is motor wind and what size is shaft 1/4 in 3/16??

[don ferrette]

ok Don , also what is motor wind and what size is shaft 1/4 in 3/16??

Motor is 1Y 1100Kv 1/4" shaft step to 3/16" prop.

[nmnorth]

sorry Don , forgot to ask , what prop?? Bill

[don ferrette]

sorry Don , forgot to ask , what prop?? Bill

Prather 235. I've run other props but the 235 is silk smooth and fast.

[RaceMechaniX]

Don,
What is the overall length? Probably would be good to know if it is NAMBA legal for Q hydro.
If you decide to sell less electronics I am interested.

Tyler

[don ferrette]

Don,
What is the overall length? Probably would be good to know if it is NAMBA legal for Q hydro.
If you decide to sell less electronics I am interested.

Tyler

Hey T you're the 2nd person to ask that, 39" from transom to front sponson tip.

[don ferrette]

This rigger is being offered for sale outside OSE as well and there is serious interest, just want to keep things on the up and up.

[don ferrette]

Rigger is SOLD pending payment.

[HOTWATER]

Nice! : )