2x Swordfish 240A esc's

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • TheShaddix
    Senior Member
    • Sep 2013
    • 759

    #16
    i did remove the on/off switch and soldered the wires together, and one of the tubes was replaced with a brass tube but it's same in size as the factory one.

    Comment

    • Cottageboater
      Senior Member
      • May 2008
      • 779

      #17
      I see you removed the programming card power connector as well. Is it still possible to use the programming card on this ESC? If it can still be programmed, I am very interested. Thanks.

      Comment

      • TheShaddix
        Senior Member
        • Sep 2013
        • 759

        #18
        It's not possible anymore unless you solder a new wire to the cut one. I programmed it via PC through the other wire.

        Comment

        • suffering79
          Member
          • Mar 2013
          • 65

          #19
          Do you still have esc

          Comment

          • TheShaddix
            Senior Member
            • Sep 2013
            • 759

            #20
            I do not.

            Comment

            Working...