2x Turnigy 60 Amp ESC's from new HK Flowmaster Cat

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • lt130th
    Senior Member
    • Apr 2014
    • 858

    #1

    2x Turnigy 60 Amp ESC's from new HK Flowmaster Cat

    SOLD

    I just pulled these out of my 36" Hobby King Flowmaster cat. They were run three times on 3s LiPo's. Worked just fine. I upgraded to 120 Amp ESC's. I for some reason only had five 4mm bullets so I had to scavenge one from one of these ESC's, but you'll probably be swapping them out for 5mm bullets or something else anyway. I have already soldered 5.5mm bullets on the battery side of each ESC. These are non-programmable. The spec sheet and instructions that came with them is attached below. They seem to have a fast start/launch, & (despite the label saying 2s-3s) the instructions state the LVC is locked at 9.8v.

    20150724_020536.jpg
    20150724_020552.jpg
    20150724_020623.jpg
    20150724_020748.jpg
    ESC_Instructions.jpg

    Thanks,
    Michael P.
    Last edited by lt130th; 08-17-2015, 07:30 PM. Reason: All Sold
  • AMP EATER
    Member
    • May 2014
    • 88

    #2
    Will you sell me Just one of them?

    Comment

    • lt130th
      Senior Member
      • Apr 2014
      • 858

      #3
      Originally posted by AMP EATER
      Will you sell me Just one of them?
      Sure. $27 shipped to US address?
      Last edited by lt130th; 07-26-2015, 11:23 PM. Reason: grammar

      Comment

      • AMP EATER
        Member
        • May 2014
        • 88

        #4
        these are only 3s??? wtheck? reallly

        Comment

        • lt130th
          Senior Member
          • Apr 2014
          • 858

          #5
          Originally posted by AMP EATER
          these are only 3s??? wtheck? reallly
          Yeah, it's weird because the label says 2s-3s, but the instructions say the LVC is locked at 9.8v...so how could you run them on 2s...right? I should also mention, they don't have a soft start. I had to pull the throttle, then immediately feather it for a soft launch. They come in a twin cat with what seem to be unmarked, 3300kv, 28mm Leopards.

          Comment

          • AMP EATER
            Member
            • May 2014
            • 88

            #6
            Originally posted by lt130th
            Yeah, it's weird because the label says 2s-3s, but the instructions say the LVC is locked at 9.8v...so how could you run them on 2s...right? I should also mention, they don't have a soft start. I had to pull the throttle, then immediately feather it for a soft launch. They come in a twin cat with what seem to be unmarked, 3300kv, 28mm Leopards.
            sorry but im gonna pass

            Comment

            • lt130th
              Senior Member
              • Apr 2014
              • 858

              #7
              Originally posted by AMP EATER
              sorry but im gonna pass
              No, you must buy it. [KIDDING] I saw the other ESC's you were looking at in the sale forum, here, & something told me these wouldn't be what you wanted. For anyone wanting to throw together an inexpensive two or three foot twin cat to run 50+ mph on 3s, these would be perfect.

              Comment

              • lt130th
                Senior Member
                • Apr 2014
                • 858

                #8
                Bump...

                Comment

                • Jesse J
                  scale FE racer
                  • Aug 2008
                  • 7116

                  #9
                  I take one please
                  "Look good doin' it"
                  See the fleet

                  Comment

                  • lt130th
                    Senior Member
                    • Apr 2014
                    • 858

                    #10
                    Originally posted by Jesse J
                    I take one please
                    Ok. I'll PM you with my Paypal address.

                    Thanks,
                    Michael P.

                    Comment

                    • lt130th
                      Senior Member
                      • Apr 2014
                      • 858

                      #11
                      One ESC sold to Jesse J. $27 shipped for the second, remaining ESC (the one with two 4mm bullets on the motor side).

                      Comment

                      • Jesse J
                        scale FE racer
                        • Aug 2008
                        • 7116

                        #12
                        I'd like the other if still for sale
                        How much?
                        "Look good doin' it"
                        See the fleet

                        Comment

                        • lt130th
                          Senior Member
                          • Apr 2014
                          • 858

                          #13
                          Originally posted by Jesse J
                          I'd like the other if still for sale
                          How much?
                          Sure! I was just thinking about bumping this thread $27? :) I can send you my paypal address again unless you still have it. I should still have your shipping address unless you want it shipped elsewhere. Let me know.

                          Thanks,
                          Michael P.

                          Comment

                          • Jesse J
                            scale FE racer
                            • Aug 2008
                            • 7116

                            #14
                            $$ sent. Same place. Thx
                            "Look good doin' it"
                            See the fleet

                            Comment

                            • lt130th
                              Senior Member
                              • Apr 2014
                              • 858

                              #15
                              Cool! I'll get it to the post office tomorrow and PM you with the tracking #.

                              Thanks,
                              Michael P.

                              Comment

                              Working...