Sale Pending
PRICE LOWERED TO $250 WITH SHIPPING TO LOWER 48 INCLUDED
RTR Impulse 31. This is a high performance, ready to run boat. Beginning drivers should use a smaller prop until comfortable with the high speeds. Asking $275.
Includes a Tacon 4074, 2150kV motor powered from an 180A Hobby Wing Sea King V2 ESC. The motor has an aluminum cooling housing. Also includes a Spektrum 2 channel transmitter and MR200 receiver.
Race ready improvements were made similar to Darin Jordan’s forum post.http://forums.offshoreelectrics.com/...-Impulse-31-V2 The hatch is reinforced and has 2 stainless flat head screws recessed into the hatch. The front deck is reinforced. The hull bottom has been blue printed (surface flattened). The battery tray system was removed to reduce weight and lower the center of gravity. The drain plug and antenna exit were removed and filled with West System epoxy. The pushrod was replaced with a stronger stainless steel one. Screw adjustment was added to the trim tabs. A new Speed Master strut blade was just added.
There is a small stress crack in the gel coat on the front of the right side of the hull. The hull stickers are showing some wear.
Extras include an upgraded 0.150” flex shaft and a 0.187” flex shaft and coupler. A new Octura 646 prop is also included.
P1010182.jpgP1010161.jpgP1010165.jpgP1010166.jpgP1010167.jpg
PRICE LOWERED TO $250 WITH SHIPPING TO LOWER 48 INCLUDED
RTR Impulse 31. This is a high performance, ready to run boat. Beginning drivers should use a smaller prop until comfortable with the high speeds. Asking $275.
Includes a Tacon 4074, 2150kV motor powered from an 180A Hobby Wing Sea King V2 ESC. The motor has an aluminum cooling housing. Also includes a Spektrum 2 channel transmitter and MR200 receiver.
Race ready improvements were made similar to Darin Jordan’s forum post.http://forums.offshoreelectrics.com/...-Impulse-31-V2 The hatch is reinforced and has 2 stainless flat head screws recessed into the hatch. The front deck is reinforced. The hull bottom has been blue printed (surface flattened). The battery tray system was removed to reduce weight and lower the center of gravity. The drain plug and antenna exit were removed and filled with West System epoxy. The pushrod was replaced with a stronger stainless steel one. Screw adjustment was added to the trim tabs. A new Speed Master strut blade was just added.
There is a small stress crack in the gel coat on the front of the right side of the hull. The hull stickers are showing some wear.
Extras include an upgraded 0.150” flex shaft and a 0.187” flex shaft and coupler. A new Octura 646 prop is also included.
P1010182.jpgP1010161.jpgP1010165.jpgP1010166.jpgP1010167.jpg
Comment