2900Kv Brushless Motor: WM [PRB3911]

[Shane Lewis]

I used this once and it does scream but isn't the right motor for racing so it's not going into any of my other boats. I cut the ends off because they were cheap connectors anyway. Asking $35 odo

[czegard]

I will take it. How much shipped to Chile?

[Shane Lewis]

Hey what your postal code headed to post office soon

[czegard]

7640794

[Shane Lewis]

$16.25 so the total would be 51.25 shipped to Chile.

[czegard]

Ok give me your PP email

[ray schrauwen]

Has the enamel been removed from the remaining wire? Usually when you cut off the connectors like that there is only wire left covered in hard to remove enamel.

[Shane Lewis]

No I haven't removed anything but the plugs, it's just like you see it. I really didn't have chance to slip them off cause I wrapped it up right after I took these pics.

[czegard]

Shane,
After some reading I found that that the work involved to strip the coating off the cables is considerable.
Before the payment, would you mind pulling back the wire insulation and see if it can be tinned?

Cheers.
Christian.

[Shane Lewis]

Ok I was able to pull one of the covers off and put it back on, I'm not sure what tinning is? It's bare wire under the sheaths, I'm not seeing any other covering.

[czegard]

As I said, the work involved to remove the enamel from the remaining wire is huge.
If you cannot confirm the feasibility of tinning new connectors, would you mind, please, selling me the motor with 5.5 male bullet connectors?
If you cannot, I will step aside from the deal......and sorry if I make you loose your time.

Christian.

[Shane Lewis]

I can do that for a few dollars more, how does $53.00 shipped sound? If so you have my pp info

[czegard]

If you cannot tin the connectors, will you send me my money back?

[Shane Lewis]

I don't think there will be a problem but yeah if there's a problem I'll refund you. I'll post a new pic of them

[czegard]

Ok, will send the payment today.
Thank you