Tweet
There's a long story behind this build but to keep it simple, i had intended to build this as a twin set up, funds got tight and some interest in rc has faded for me currently. I had the twin stingers mounted and the boat sat. was going to sell it and decided to just build as a single. so the stinger mounts are still on the transoms in their proper locations. I figured leave em on there, they will not effect the performance of the hull in any way. If i decide to build as twin later they are there. so this boat will come with the stingers for a twin setup.
this has genesis struder with upgraded ose strut and dual pickup rudder. Pull pull steering setup with scale like hydraulic linkage, 3/16 cable, 642 prop, leopard 3674 2650, carbon mount, metal gear servo in custom mount, 4mm kintec cooling lines, spectrum reciever. comes with 110mm stingers for twin set up. NO ESC!!! Will need esc to be complete!! Again, this is a complete set up MINUS esc. INSTALL A ESC AND ITS READY TO GO!!! Will need to be dialed in, should be a strong runner.
I bought the hull used from a member here and I have ran it once in its current configuration. Mono Jeff did the custom graffics, the are a chameleon orange to green and look awesome. West System epoxy used throughout. It is a used hull, sponson tips have minor chips and some hole have been filled. But this hull is straight as an arrow and riding surfaces are sharp.
More pics upon requestboat pics 023.jpgboat pics 022.jpgboat pics 024.jpgboat pics 025.jpgboat pics 026.jpg
PRICE REDUCED!!
$400 SHIPPED
this has genesis struder with upgraded ose strut and dual pickup rudder. Pull pull steering setup with scale like hydraulic linkage, 3/16 cable, 642 prop, leopard 3674 2650, carbon mount, metal gear servo in custom mount, 4mm kintec cooling lines, spectrum reciever. comes with 110mm stingers for twin set up. NO ESC!!! Will need esc to be complete!! Again, this is a complete set up MINUS esc. INSTALL A ESC AND ITS READY TO GO!!! Will need to be dialed in, should be a strong runner.
I bought the hull used from a member here and I have ran it once in its current configuration. Mono Jeff did the custom graffics, the are a chameleon orange to green and look awesome. West System epoxy used throughout. It is a used hull, sponson tips have minor chips and some hole have been filled. But this hull is straight as an arrow and riding surfaces are sharp.
More pics upon requestboat pics 023.jpgboat pics 022.jpgboat pics 024.jpgboat pics 025.jpgboat pics 026.jpg
PRICE REDUCED!!
$400 SHIPPED
Its not the boat its the driver
Comment