Tweet
As much as I hate to sell it, I must make room and funds for my next project 
There's no cracks or damage anywhere. This thing is pristine. It will get a nice buffing and wax job before going out. I just put a larger rudder on it last night, it was spinning out at slow speeds if I turned it sharply. The rudder I had was too small for this hull. It's going complete, ready to run except receiver. Throw your Batts and a receiver in and go. Its setup to run 4s, 5s or 6s. Goes about 50mph on 4s, and does a gps' ed 62.0mph. I made several 62mph passes to verify. Here's the lowdown:
Bought brand new castle 1717 motor. 1650kv
Fightercat 101 esc, no external cap bank but it will be included
carbon fiber inlay
Carbon fiber battery trays
Aluminum fightercat motor mount for 1717 motor
Carbon fiber cooling sleeve
Waterproof ose servo
Hobby wing ubec
Ec5 concord
Fightercat strudder
Foam sheeting in the nose for floatation. Lightly siliconed in place so it's remove able
Carbon reinforced canopy with foam integrated into the canopy
3/16 flex
Large heavy duty hatch locks
Kbb hatch foam seal
X447/3 prop s/B
Fightercat logo water outlet
Fightercat water hose bulkhead connector
Balanced Octura collet
mono Jeff windshield
I have extra graphics for it I never installed. Included
It will come with a brand new flex cable installed. I'm going test run it Saturday morning to make sure the rudder works correctly. I'll take $650obo plus shipping.
There's no cracks or damage anywhere. This thing is pristine. It will get a nice buffing and wax job before going out. I just put a larger rudder on it last night, it was spinning out at slow speeds if I turned it sharply. The rudder I had was too small for this hull. It's going complete, ready to run except receiver. Throw your Batts and a receiver in and go. Its setup to run 4s, 5s or 6s. Goes about 50mph on 4s, and does a gps' ed 62.0mph. I made several 62mph passes to verify. Here's the lowdown:
Bought brand new castle 1717 motor. 1650kv
Fightercat 101 esc, no external cap bank but it will be included
carbon fiber inlay
Carbon fiber battery trays
Aluminum fightercat motor mount for 1717 motor
Carbon fiber cooling sleeve
Waterproof ose servo
Hobby wing ubec
Ec5 concord
Fightercat strudder
Foam sheeting in the nose for floatation. Lightly siliconed in place so it's remove able
Carbon reinforced canopy with foam integrated into the canopy
3/16 flex
Large heavy duty hatch locks
Kbb hatch foam seal
X447/3 prop s/B
Fightercat logo water outlet
Fightercat water hose bulkhead connector
Balanced Octura collet
mono Jeff windshield
I have extra graphics for it I never installed. Included
It will come with a brand new flex cable installed. I'm going test run it Saturday morning to make sure the rudder works correctly. I'll take $650obo plus shipping.
Comment