Tweet
SOLD SOLD SOLD
Selling one of my Miss Geico 29" I am located in Canada and therefore shipping to the US will be more than CONUS shipping, but if you're in Canada then it won't be much. Because of this I am asking $300can (about $275us) plus ACTUAL SHIPPING - The hull has had some work done to it after the stock wood battery tray broke loose, its ready to handle more power. I removed the trays and reinforced the hull seams with 2 layers of glass on the inside and one layer on the outside, this substantially stiffened up the hull. I then had the white painted over the work, added the pin stripe and had a couple layers of clear applied and put on new decals (paint is quality auto paint not rattle can). I then installed custom made battery trays in a lower position. It also comes with an upgraded Flex/Drive shaft, Kintec custom strut bushing and offset rudder bracket, I trimmed back the strut mount to accommodate a bigger prop if you want to upgrade the electronics and go bigger down the road. Comes with the original V1 electronics w/5.5mm bullets, MR200 RX and basic TX. (stand not included) the hatch seal is included, there is a small crack in the hatch but its sealed, new plastic hatches are cheap. Just need some Lipo's and its ready to go. I can include a proboat upgraded steel prop in raw form.
I will try to package it this week so I will be able to get shipping quotes. Forgot a pic of the bottom of the hull but I'll get one shortly.
Selling one of my Miss Geico 29" I am located in Canada and therefore shipping to the US will be more than CONUS shipping, but if you're in Canada then it won't be much. Because of this I am asking $300can (about $275us) plus ACTUAL SHIPPING - The hull has had some work done to it after the stock wood battery tray broke loose, its ready to handle more power. I removed the trays and reinforced the hull seams with 2 layers of glass on the inside and one layer on the outside, this substantially stiffened up the hull. I then had the white painted over the work, added the pin stripe and had a couple layers of clear applied and put on new decals (paint is quality auto paint not rattle can). I then installed custom made battery trays in a lower position. It also comes with an upgraded Flex/Drive shaft, Kintec custom strut bushing and offset rudder bracket, I trimmed back the strut mount to accommodate a bigger prop if you want to upgrade the electronics and go bigger down the road. Comes with the original V1 electronics w/5.5mm bullets, MR200 RX and basic TX. (stand not included) the hatch seal is included, there is a small crack in the hatch but its sealed, new plastic hatches are cheap. Just need some Lipo's and its ready to go. I can include a proboat upgraded steel prop in raw form.
I will try to package it this week so I will be able to get shipping quotes. Forgot a pic of the bottom of the hull but I'll get one shortly.
Comment