tc6.1 touring car FS

[steveo]

Hey guys I have a nice tc6.1 artr, all is included in pics, extra part new tires one stock and 2 mod motors 3.5 and 5.5 , 120 amp speedo hitec servo (fast) and roll of battery tape- could use a new body it was off another car

Lower price now $320

[fla350tt]

are you interest in any trades for boats

[steveo]

Its possible. Whatcha got

[fla350tt]

Phil Thomas sport hydro, custom paint, speed master hardware. I would be looking to even trade boat, custom stand & hardware, no electronics
004.jpg003.jpg

[fla350tt]

this is the boat stand

http://forums.offshoreelectrics.com/...-Stealth-Stand

[steveo]

Looks very nice can I have an interior and hardware pic, have u run it and on what setup , I am interested

[fla350tt]

yes I have run it. first set up was castle 240 esc & castle 1515/1y on 4s2p w/ m445, pulled over 200 amps avg speed low 50's. I have now gone to all 6s set ups in most of my boats. had a swordfish pro 220 and a leopard 4074 1400kv on 6s about the same spd, amps were around 160. I have had the boat up 64mph but it is a handful to keep on the water. there is one crack in the paint on the left side of the boat, the chip is about 1/4" long but there is a crack about 2" long( not easy to see in the pic. this inside pic is with the castle set up. this was my first build and I found out the carbon fiber cloth likes to come apart, and shows up really bad if you do not lay down a big piece first, then adding everything in the boat

[fla350tt]

this hardware has only 2 runs on it. and where about are you in Florida? im in Daytona.

[fla350tt]

since I had the boat on the bench I cleaned it up and laid down some new carbon fiber, been wanting to do this for awhile. alittle more touching up and its ready for a new pilot

[steveo]

I have thought this over I am going to have to pass I am really looking to shrink down in prep for a move I have a few I don't play with and a boat I have not put in the water yet because of lack of funds for batterys. Any other time I would jump on it, if still interested I could lower the price $320

[steveo]

Bump

[steveo]

Still for sale, moving to new place would like to see this gone

$320

[steveo]

Ok still for sale now minus esc and 17.5 motor, $215 shipped