Neu1521-1d neu1518-1.5d tp0460-4d fc300a 2-6s

[HTVboats]

NEU 2900.jpg
Neu 1521 1D 2900kv 5mm shaft $140 Checked out and new bearings installed by Neu recently


TP2600.jpg
TP 4060 4D 2600kv 40X92 5mm shaft finned case $50


NEU2340.jpg
Neu 1518 1.5D 2340kv 5mm shaft. (last run borrowed to Mike Whitley at Huntsville to set IMPBA P mono 2 lap record in Oct.) $140 SOLD



FIGHTERCAT.jpg

FighterCat 300a 2-6s ESC with new cap bank and FC program box. Programs but I can't get it to work at full throttle. Ran then cut out. been sitting on the healing shelf for a while. Project for someone $30 as is. SOLD

prices include shipping lower 48. Motors have shafts cut to aprox 15mm for outboard use. Still work fine as inboards. Not a lot of time on any of the 3. Used for record testing.
Mic

[capnswanny]

I'll take the FC setup please!!
Thanks,
Corey

[longballlumber]

I will take the 1518

Thanks
Mike Ball

[G.Rose]

I have New castle Creation 1515 1y. I put it in my P Mono then took it out because my friend gave me Neu 1515. It has a cooler and 5.5 connectors. Would you be willing to swap your 1521 for it. I also have re-build kit that I will include. I purchased it all at once.

[HTVboats]

I have New castle Creation 1515 1y. I put it in my P Mono then took it out because my friend gave me Neu 1515. It has a cooler and 5.5 connectors. Would you be willing to swap your 1521 for it. I also have re-build kit that I will include. I purchased it all at once.

If you haven't shortened the motor lead wires too much so I can use it as an outboard I'll do the trade.
Mic

[G.Rose]

I'm sorry I need a 1.5 D I should have put my glasses on.

[tagasagwan]

Next in line for the FC stuff. thanks!-Stephen-

[capnswanny]

Picked up MO today, will go out in the morning mail.
Corey

[capnswanny]

Mic, I got my box of goodies today...time to start playing!
THANKS!!!
Corey

[HTVboats]

Payments received from Mike and Corey

[bracka69]

Do you have a water jacket for the TP or know what jacket would fit it?

[HTVboats]

As an outboard with fins the motor doesn't heat in free air. A Castle 1515 jacket works though. The 1521 Castle cooling jacket has the water pickups too far apart.
Mic

[bracka69]

Ok thanks. How much use and what cell lipos did you use on the TP?

[HTVboats]

Used the motor on 4S. Ran it for SAW testing maybe 10 passes not at the same time. (prop changes) Never ran long enough to heat up. performance was inbetween a 1515-1518 Neu. There is a thread going here on water jackets for TP motors.
Mic