Tweet
I'm upgrading to a real boat so a few toy's need to be sold off due to lake of use.
This boat was set up with twin 1717's and then rebuilt with the Castle 2028 780kv motor, swordfish 300hv pro esc and runs on 10s nano tech lipos. I'll sell this as a bind and drive sith a spectrum mr200 marine RX and a Losi 3000mAh 6v pack, 2x 6s Nano Tech 45-90c 5000mAh lipos, 2x 4s Nano's 45-90c 5000mAh with cables fitted with 8mm bullets to make up the 10s2p 10000mAh power source. The steering servo is a Hitec HS 7955-TG, the sf300 hv pro esc is fitted with a spark arrestor and large Etti Cap bank. The hardware is speedmaster, 1/4" shaft, the motor mount from Off Shore Electrics as with the B&S X457 prop. The hull has been reinforced with Carbon/Kevlar cloth as with the hatch. The boat is a great fast boat with plenty of potential once it gets trimmed up properly. The hull has a few marks but otherwise ready to be painted up to become a pride of the fleet boat.
For full build details click here
http://forums.offshoreelectrics.com/...ild&highlight=
I've ran it a couple of times and haven't played around with the strut height or angle and it's had a little bounce but never looked like going over, it'll sit right up on the prop and hold balance very well even in rough windy conditions.
Here's a video of a test run
Now selling for only $800 + Postage
If you live in the Melbourne area I can deliver it for free on the 7th Jan.
This boat was set up with twin 1717's and then rebuilt with the Castle 2028 780kv motor, swordfish 300hv pro esc and runs on 10s nano tech lipos. I'll sell this as a bind and drive sith a spectrum mr200 marine RX and a Losi 3000mAh 6v pack, 2x 6s Nano Tech 45-90c 5000mAh lipos, 2x 4s Nano's 45-90c 5000mAh with cables fitted with 8mm bullets to make up the 10s2p 10000mAh power source. The steering servo is a Hitec HS 7955-TG, the sf300 hv pro esc is fitted with a spark arrestor and large Etti Cap bank. The hardware is speedmaster, 1/4" shaft, the motor mount from Off Shore Electrics as with the B&S X457 prop. The hull has been reinforced with Carbon/Kevlar cloth as with the hatch. The boat is a great fast boat with plenty of potential once it gets trimmed up properly. The hull has a few marks but otherwise ready to be painted up to become a pride of the fleet boat.
For full build details click here
http://forums.offshoreelectrics.com/...ild&highlight=
I've ran it a couple of times and haven't played around with the strut height or angle and it's had a little bounce but never looked like going over, it'll sit right up on the prop and hold balance very well even in rough windy conditions.
Here's a video of a test run
Now selling for only $800 + Postage
If you live in the Melbourne area I can deliver it for free on the 7th Jan.
Comment