Neu 2230 1Y 8mm Finned w/fan New in Box

[RaceMechaniX]

Guys,

I have an unused Neu 2230 1Y with 8mm shaft and internal fan produced in October of 2012. Note: this is the finned version which I modified. The center most fins have all been turned down and at either end one fin has been removed to make a wider O-ring gland. I had planned on slipping a smooth bore jacket over the top, but never got around to it.

Motor shaft is uncut and this has the good magnet lead wire exiting the motor not the silicon leads. I did add some fiberglass insulation around the leads and more shrink to protect the leads exiting the motor end bell.

Asking $550 shipped CONUS. Shipping overseas is available at buyers cost.

IMG_0657.jpgIMG_0658.jpgIMG_0659.jpgIMG_0660.jpg

[photohoward1]

What about a cooler for it? What did you use?

[RaceMechaniX]

Was planning on either buying the jacket from Fast Electrics in AUS, or sourcing some 2.5~2.625 ID carbon or aluminum tube. The motor OD is right at 2.5".

TG

[trddrift]

Hey bud, is this motor still for sale?

[RaceMechaniX]

Yes still have it.

[trddrift]

Great will you ship to Aus? & would you recommend this motor for a 50in tunnel hull.

[RaceMechaniX]

Yes I can ship to AUS. Replied to your PM about using it in a tunnel.
TG

[angryevo8]

has the motor been sold, if not i am interested

[RaceMechaniX]

Yes still available.

[angryevo8]

PM Sent


Please keep all deals on the forum before the smoke starts rolling.

Thanks

D.

[RaceMechaniX]

No deals yet, he was just inquiring about shipping.
TG

[angryevo8]

what ESC had you planned on using with this motor, and what volatge?

[angryevo8]

Ill take it

[RaceMechaniX]

OK John,

I will split the difference in shipping costs with you. PM sent with PP address.

I would use one of the following options. A Schulze 40.160/32.200/40.300, MGM 25063/40063, Swordfish 300, MPB ESC or a Castle Hydra ICE 200. I was planning on running this on 10S, but it will also run on 12S.

TG

[RaceMechaniX]

Sold, payment received.

Tyler