Hey guys, I'm looking to sell my heavily upgraded pro boat mystic.
15 cycles on battery, 10 on motor and esc, 1/2 run on upgraded kintec flex cable and collet, 1/2 run on brand new hull, (front half of the sponsons are filled with expanding form from kintec to add some sturdiness to the front)
Tacon 4074, 2200kv.
Turnigy 180 amp esc ver. 3, (with program card)
2 gens ace 5000 mah 7.4v 40c lipos (roughly 15 cycles on batteries)
Stock servo.
5.5mm bullets all the way around batt and esc, motor.
Never been under water, as stated earlier, hull has ONE run on it, cracked the old one and just set this one up ran it last time at the lake and didnt enjoy it like I used to! Really bummed I'm at this decision as the boat is a great boat, but I lost my setup when I sold the old one. Before it was doing up to about high 40s pushing 50 probably.
Have the stock flex cable and collet I will include.
3 props, an m445 (sharpened and balanced by a member on here.)
X642 (bought sharpened and balance from ose)
And the lame stock prop! XD
1/2 foot of black cooling tube that I had left over, from kintec.
NO CHARGER! Stock pro boat transmitter included, rx not installed but does come with it. (Flysky RX is installed and will come with it but NO flysky TX!!!!)
Only thing it doesn't include.
I'm asking about $285 shipped (Make some offers, worst I can say is no)
(Just a heads up, the last time I greased the cable which was not but a week after I left the lake, and just again recently before I put it up, I did not tighten the collet, I just minimally tightened it.)
Another add will be posted on URC, just a heads up
15 cycles on battery, 10 on motor and esc, 1/2 run on upgraded kintec flex cable and collet, 1/2 run on brand new hull, (front half of the sponsons are filled with expanding form from kintec to add some sturdiness to the front)
Tacon 4074, 2200kv.
Turnigy 180 amp esc ver. 3, (with program card)
2 gens ace 5000 mah 7.4v 40c lipos (roughly 15 cycles on batteries)
Stock servo.
5.5mm bullets all the way around batt and esc, motor.
Never been under water, as stated earlier, hull has ONE run on it, cracked the old one and just set this one up ran it last time at the lake and didnt enjoy it like I used to! Really bummed I'm at this decision as the boat is a great boat, but I lost my setup when I sold the old one. Before it was doing up to about high 40s pushing 50 probably.
Have the stock flex cable and collet I will include.
3 props, an m445 (sharpened and balanced by a member on here.)
X642 (bought sharpened and balance from ose)
And the lame stock prop! XD
1/2 foot of black cooling tube that I had left over, from kintec.
NO CHARGER! Stock pro boat transmitter included, rx not installed but does come with it. (Flysky RX is installed and will come with it but NO flysky TX!!!!)
Only thing it doesn't include.
I'm asking about $285 shipped (Make some offers, worst I can say is no)
(Just a heads up, the last time I greased the cable which was not but a week after I left the lake, and just again recently before I put it up, I did not tighten the collet, I just minimally tightened it.)
Another add will be posted on URC, just a heads up
Comment