37" Fightercat Daytona built by KBB

[smittyj77]

Boat has never been run, I've had it since June.

Boat was built bu KBB Carbon fiber inlay,

Hatch is in high build primer and has knicks out of it, was like that when I got it.

FC 2 Bolt Profile Series Motor Mount- Carbon Fiber
Hex Collet Coupler 5mm-.187 or 3/16"
FC Battery Tray - Carbon Fiber x2
FC Water Inlet - Large
3/16" Brass Stuffing Tube (7mm OD)
FC HD Strut/Rudder - Offset 3/16" 115mm w/Pickup
3/16" Teflon Liner for Brass Stuffing Tube (7mm OD)
FC 4 Bolt Profile Series UNIVERSAL 4082 - 4092
3/16 Tapered Prop Nut - Small
Servo
Carbon fiber servo mount mounted through hull
hull seal
hull thumb screws to latch it down
custom fightercat water outlet
s222 prop and s215 I think
Sticker kit for windshield hatchs etc.
Custom fightercat water outlet

Leopard 4082 2200kv motor
Seaking 180amp ESC

550$ Plus shipping,

Sent from my Z10 using Tapatalk 2

[Speedracer128]

What speeds is the boat doing with that setup? I want a fightercat for my next boat but leaning towards the rivercat. Same width but lighter and shorter. In my current mean machine I have your similar setup except the motor is a little bigger with a lower kv so I can use 6s for batteries.


No disrespect but I can do $400. Can we do business?

[Dastuffuwant]

are you looking for any other rc trades

[smittyj77]

Boat is sold

Sent from my Z10 using Tapatalk 2


Edit: Boat was sold off site.