-
Last edited by JMSCARD; 09-12-2013, 09:17 AM. -
MHZ underside.jpgMHZ Seams.jpgMHZ micro.jpgMHZ props.jpg
more pics.
and a cool vid of someone else Micro Iceberg... I liked this one :)
oh and here is the DX4 I will include if someone is needing it closer to rtr (it is as new as was in a RTF plane heli that I used my fancier Spektrum TX instead, I thought it would be neat to use a stick TX)... the AR 7000 rxr with satellite that would be included can be seen off to the side of the guts pic..
dx4.jpgLast edited by JMSCARD; 09-09-2013, 03:08 PM. -
Would a Lerner 1940/4 3914kv work in
This?Comment
-
mhz props 2.jpg More prop pics.
I believe the lehner 1940 is a 36mm motor... this boat uses a 28mm which is more then enough for sure, the traxxas vxl 380 is a 4000kv and 48mm can length, and on 3s should make the boat quite ballistic to say the least and about as much power would be useable in this boat, if I had to guess propped right should see 60... I did some research before deciding which motor to go with...
here is one in the MHZ micro icebergs sibling mono...
that's on 3s 1600mah, and lets face it if you wanted to get crazy you could try 4s for saw like runs, but that would be 59,000 rpm or thereabouts
Last edited by JMSCARD; 09-09-2013, 03:09 PM.Comment
-
Would you ship Hull/Hardware/Hitec Servo/Wire drive for $150 to Canada?Comment
-
There is a water entry point (brass tubing nicely through hull)
But I was going to run it without for now as I think it would run fairly reasonable temps on 2, and 3s... would be easy to upfit one obviously.
The boat hull alone is $136 plus shipping with NO hardware, no Hitec servo, no motor mount, no Jeff wholt wire drive, No Prop(s).
I also paid $59 for the motor at RC madness in Enfield CT.... not that you are going for the motor anyway but its a very good motor for the boat.... folks have used them in high powered micros with exceptional results.
Also the original owner from whom I purchased it is in my mind and many folks here one of the most knowledgeable FE guys out there, and is a very well respected racer ... which is one of the main reasons why I bought it as well.... I also didn't even want to upfit it with the larger wire drive myself and asked him to do the upfit on my dime prior to shipping, which he did very kindly. As much as someones time is tough to pay for, its hard to say its not nice to get a boat built by a pro at no cost? this one is basically built for free at 65% off parts cost.
I will let you know, but I think it will sell as its a very fair price, its on other forums as well.Last edited by JMSCARD; 09-09-2013, 04:57 PM.Comment
-
Ya I find it is usually cheaper to get direct from Germany at least to Canada anyway.
If you want a quick sale I could go to $165 shipped cheapest option through USPS and maybe throw in a couple props? If you want to wait for your asking price that is cool to.Comment
Tweet
Comment