Tweet
SOLD
For Sale is my Proboat Impulse 31 in near flawless condition. $350 shipped for everything or I will consider breaking it up for $200 shipped for the hull and hardware, $80 for the motor shipped, and $80 for the ESC shipped. This is not your typical Impulse. I bought this second hand here on OSE and began working on it as soon as it arrived. I ran it in two races in district 12 IMPBA with a Castle motor and only a few other times with a brad new Leopard. I am selling it to buy a FE30. I am also throwing in a dual rudder convestion kit and an extra flex shaft. Shipping is to the lower 48 USA. Here are the details:
- 1st generation hull, 2nd generation graphics
- Seaking 180 ESC with extra caps and custom wood mount
- Leopard 4074 2000kv motor (only 3 runs on motor)
- Teflon bushing installed in the strut
- Octura 5mm collet
- Dual rudder kit included
- OSE Upgraded flex shaft
- Standard flex shaft also included
- Speedmaster trim tabs
- OSE upgraded turn fins
- Upgraded cooling lines 7mm thick- custom ESC mount and motor support brace
- Carbon fiber lined hatch, (rock solid and prevents hatch breakage if it rolls)
- Dual stainless water outlets
- Dual 6.8mm cooling inlet rings
- 5.5mm bullets for the battery
- 6.5mm bullets on the motor
- Aluminum Antenna Mount
-
-
-
-
-
For Sale is my Proboat Impulse 31 in near flawless condition. $350 shipped for everything or I will consider breaking it up for $200 shipped for the hull and hardware, $80 for the motor shipped, and $80 for the ESC shipped. This is not your typical Impulse. I bought this second hand here on OSE and began working on it as soon as it arrived. I ran it in two races in district 12 IMPBA with a Castle motor and only a few other times with a brad new Leopard. I am selling it to buy a FE30. I am also throwing in a dual rudder convestion kit and an extra flex shaft. Shipping is to the lower 48 USA. Here are the details:
- 1st generation hull, 2nd generation graphics
- Seaking 180 ESC with extra caps and custom wood mount
- Leopard 4074 2000kv motor (only 3 runs on motor)
- Teflon bushing installed in the strut
- Octura 5mm collet
- Dual rudder kit included
- OSE Upgraded flex shaft
- Standard flex shaft also included
- Speedmaster trim tabs
- OSE upgraded turn fins
- Upgraded cooling lines 7mm thick- custom ESC mount and motor support brace
- Carbon fiber lined hatch, (rock solid and prevents hatch breakage if it rolls)
- Dual stainless water outlets
- Dual 6.8mm cooling inlet rings
- 5.5mm bullets for the battery
- 6.5mm bullets on the motor
- Aluminum Antenna Mount
-
-
-
-
-
Comment