Proboat Impulse Hull and Hardware with extras, never seen water

[roadrashracing]

This has been a crappy spring so I have yet to be out boating. I bought this over the winter but never had a chance to run it. There are some flaws, one of the motor mount nuts started to spin free so I had to remove the wood mount and re-glue that. As long as I was doing that, I put a coat of epoxy on ever would surface that I could reach, I also put a coat of fiberglass resin on every surface I could reach. The pin for the drive dog was bad so i put a spartan drive dog on. There is just a really small part of liner right by the motor because I was going to upgrade the flex. I got 2 grim props that where never touched. The electronics I am throwing in, the esc worked, some kind of hobbyking 120 amp I think, the motor works but is junk, think of them as freebies. Some of the hardware was never even put on. I also got a proboat cover that will go with it. All my time will be going to my gass boat, otherwise I would not sell this.Any questions please ask. I am asking $165 with insurance to the lower 48 states.

[nitronuts]

ill offer 145

[roadrashracing]

I'll have to pass for now.

[Hor2012]

So you're not 100% sure the motor and esc work?

[roadrashracing]

They both work, but I had the motor taken apart this winter and its pretty much shot. I got the mid 30s with this setup on 3s.

[Garrett]

Is it still available for purchase? I'll offer $155.00.

Sent from my C771 using Tapatalk 2