1/8th scale miss budweiser hydroplane aeromarine laminates hull and extras for build

[electricmark]

Just never got around to use this stuff effectively. I have quite a few parts for a 1/8th scale fast electric build:

Hull

Miss budweiser 1/8 scale hull with electric motor mount and traxxas 1/8 scale waterproof servo with cutouts for proper cg balancing when adding batteries. comes with speedmaster turnfin, rudder, strut, stuffing tube w teflon liner and 3/16 flex cable and cooling lines already in place. Ran only a few times in the water.

$220 obo

Brand new 22.2V 10,000mah lipos

2 pieces of 10,000 mah, 22.2V high rate lipo 30C batteries ordered directly from the manufacturer, BRAND NEW! Dimensions of 63x45x264. Fit perfectly in the hydro.

$199 a piece obo

High Voltage ESC

Fighercat racing 3-17s lipo (11-75) very high voltage esc with 150A current capability and a capacitor bank that was always run with it. never pushed this thing and it is in perfect working order.

$180 obo

Leopard 56-92 730kv boat motor

Barely used leopard 56-92 730 kv motor (8mm shaft) with oversize cooling jacket, thrust bearing and collet for 3/16 flex shaft. Never run hot, bearings always lubed and in perfect working order.

$185 obo

Props and prop balancer all brand new

two beryllium copper props. octura 1270 (1.2 pitch 70 mm diameter) becu and octura 2.6 (1.8 pitch 66 mm diameter) both two blade brand new never used. ALso octura PBS propeller balancing stand.

$60 for all three or obo

[JimClark]

Add a pic of the props and balancer please

Jim

[nmnorth]

i'll offer $150.00 for esc, Bill

[electricmark]

I can't seem to add them. When I try and upload them, I see a red exclamation point

[lenny]

It is only five pictures per post,
Try putting them in post #4.

This one.

I can't seem to add them. When I try and upload them, I see a red exclamation point