Brushed esc's w/deans

[arnie84]

ok thnx since u pre programed it that will work just hope it picks up what size voltage lipo im gonna run on each one

[arnie84]

Sent u a pm

[JimClark]

It is not a USB cord so it is wired differently. I will have to look I may have the software if you can find the cord

[arnie84]

Ok thnx I know there all good just getting them to work lol

[arnie84]

Pm sent still can't get them too work

[G.Rose]

I found the cord to the computer but as for instructions I haven't any .
[email protected] This is the gentleman that made them and I know when I put them away they worked great. Pm your address again to me and I will mail this cord out. I'm sorry for this. If andy can't help I will rectify it. Sorry again.

[arnie84]

Address sent I will email him thnx

[JimClark]

And I do have the software pm your email and I can send it

[Alexgar]

Pm sent still can't get them too work

keep in mind these are opto no bec most of his hv esc were

[arnie84]

What exactly does that mean? Lol. My orginal model hydra esc says no bec also

[JimClark]

you use a reciever battery

[JimClark]

Also if I remember right all you really are changing is the Lipo cutoff voltage

[arnie84]

Im not useing a receiver battery so what voltage can I use & it can be a lipo?

[G.Rose]

Thanks guys for helping. Keith you can use a 6volt or even the tray that holds 4 AA batts.

[arnie84]

Ok gonna test that....