Tweet
Unfortunately some circumstances arose, and I won't have time for a while to even consider finishing my build. I've just moved to a town that's too far from water anyhow. So I'm selling the FE drambuie. I'd rather hang on to her than part it out, so please don't ask me.
$950 for the setup
Here's what comes with it:
Mhz drambuie 54" cat carbon fiber inlay, drives, rudder, outlets/inlets cut
Horracing 1/4" stinger drives polished and machined to work with the setup
Horracing scale rudder, polished
4 large water outlets on transom
Two t-handle carriers
Two hor racing cowl locks
Two 8mm-1/4" collets
Four 1/4" drive dogs
Two carbon fiber servo mounts
~20 m4 10mm screws
~10 grub/set screws unknown size
Two dual sponson water inlets
Two rubber boots for pushrods
Two 4-40 push rods
Two pull pull cables
One aluminum antenna tube mount
Three 1/4" flex shaft savers
Two 1/4" flex shafts welded to 1/4" stubs with bullet nuts
Two ose brass tubes, not bent
Two proteus 524-2t 910/1580kv motors
Two kinetic racing bottom mount motor mounts aluminum
$950 for the setup
Here's what comes with it:
Mhz drambuie 54" cat carbon fiber inlay, drives, rudder, outlets/inlets cut
Horracing 1/4" stinger drives polished and machined to work with the setup
Horracing scale rudder, polished
4 large water outlets on transom
Two t-handle carriers
Two hor racing cowl locks
Two 8mm-1/4" collets
Four 1/4" drive dogs
Two carbon fiber servo mounts
~20 m4 10mm screws
~10 grub/set screws unknown size
Two dual sponson water inlets
Two rubber boots for pushrods
Two 4-40 push rods
Two pull pull cables
One aluminum antenna tube mount
Three 1/4" flex shaft savers
Two 1/4" flex shafts welded to 1/4" stubs with bullet nuts
Two ose brass tubes, not bent
Two proteus 524-2t 910/1580kv motors
Two kinetic racing bottom mount motor mounts aluminum
Comment