arrow shark tbar shaft oiler

[RIPFENCE]

selling an arrowshark shaft tbar oiler/stuffing tube support..new in package..the stuffing tube size hole is 9mm..

35.00 shipped to con US via usps priority

please post here no pm's on this one


thanksSALE 003.jpgSALE 002.jpg

[kevinpratt823]

Does it fit 4" or 5" rail spacing?

[runzwithsizorz]

I have one of these, though it is the older model. Even if the oiler is not used, it is still the snazzyist tube support that you can buy for rail mounts!
Please note the tube hole is large, but I shrouded it with a short length of flex tubing for a nice snug fit. It also better directs the oil into the brass.
Also note, this is for 5 inch rails, to my knowledge, you CANNOT find this for 4 inch, but with my Dremel, and tap&die I adapted
The price Rip is asking is pretty darn generous!

http://www.arrowshark.com/T-bar.php

[kevinpratt823]

As long as it fits 5" rails and accomodate a stuffing tube for 1/4" flex somehow, I will take it Rip. Just give me your paypal info and I'll pay up.

[RIPFENCE]

its for 5 inch rails and can accomodate any tube for 1/4 flexes..2012 version too

paypal is [email protected]

kevin please leave your shipping address with your paypal

thanks again

pending payment

[kevinpratt823]

its for 5 inch rails and can accomodate any tube for 1/4 flexes..2012 version too

paypal is [email protected]

kevin please leave your shipping address with your paypal


thanks again

pending payment

Payment sent, you did mean to put (2) i's in your paypal address, right?

[RIPFENCE]

Sold!!

Yes 2 ii's is good common question for me
Will ship monday
Thank you

[RIPFENCE]

item shipped should have it by wed or thurs..thanks kevin

[kevinpratt823]

item shipped should have it by wed or thurs..thanks kevin

Got it, thank you.