Lehner 3060 LK/16 New

[sofus]

Lehner 3060 Lk/ 16 with Wk, Motorclams and Coupling 10mm X 1/4
Everything is new just tested

I have this brand new Lehner torque Monster that I do not need
Dimensions 60 X 112 MM without WK. 438 Kv - 8000 W - 10 mm shaft
See more specs...http://www.lehner-motoren.com/series30/

Price $430 For all + shipping $45 ( Shipping from Denmark with T & T, with insurance )

Brian

[RaceMechaniX]

430kV in Delta, this is a very high voltage motor. What voltage were you planning on running this?

[sofus]

Hey
I was going 60 v (16s) and a very large prop in a 45 hull


Brian

[sofus]

Hey


New Price $400


Brian

[trddrift]

can the motor be wired for higher kv.?

[trddrift]

Anyone......

[chris]

430 D or 250 Y

Chris

[sofus]

Hey
Yes Chris 438 kv in D
Thanks
However, the torque for rotating any Prop.

Brian

[trddrift]

Thanks for your reply i have a 50in tunnel hull with the motor mounted inboard through a mhz zdrive, the motor i was running was a tp5850 7y 580kv on 12s with a x462/2 performance was not great maybe this motor will work.???

[drwayne]

@trddrift.. use a 3 blade prop like 5714/3 from propshop

[sofus]

Hey Trddrift
Which esc and lipoer sailed you with, it's a very large Hull you have, and TP-motors is also very powerfull.

Brian

[trddrift]

Help!!!

The hull is an Australian built 50'' tunnel hull by Mark Jordan i'm using 300 amp swordfish hv controller and TP5850 7Y motor with the new MHZ Zdrive and 2x6s zippy 45c 5000 packs. The problem i have is the drive
is 1/4 inch shaft so its hard to run or find anything under 60mm with x 460 prop. On the data log was pulling 170amp tp state 125 amp continuous on the 5850 7y. My understanding is that this motor combined with 12s and this prop would have had a much lower amp draw. Hence the reasoning behind wanting Lehner 3080 or new 2225 something around 600 kv. Here are some pictures of my boat, any help would be much appreciated as i am starting to get fairly frustrated considering the amount of work i have put into this hull. IMAG0371.jpgIMAG0372.jpgIMAG0366.jpgIMAG0356.jpgIMAG0368.jpg

[drwayne]

Gday
just sent a pm