fs vacupickle hull hardware

[steveo]

well i bought a revolt to run in a spec class and need some funds i only need 2 boats so this is the one that has to go, check my build thread for pics for now until i get a few new ones up


- factory built
- randy naylor hardware
- hitec 225 servo
- ul-1 turnfin w/ hd bracket
-2x cowls

- there is 2 small bubbles at the strut where i got alittle to close with the heat to shrink some tubing

$130 shipped lower 48-SOLD

http://forums.offshoreelectrics.com/...ild&highlight=

[darrin4800]

pics with the cowl on it.

[mv301]

I'll take it! Send me email for PayPal.

[JimClark]

Please post the pics in your thread

[steveo]

new pics

[steveo]

pp addy is [email protected]

[mv301]

Thanks Steve- money sent

[mv301]

You don't happen to have the cowl decals for windshield etc?

[steveo]

that i dont have- thanks shipping asap

also new flex shaft u will have to cut to fit to ur motor coupler

[mv301]

Did this ship yet? Tracking numbers please.
Thanks

[steveo]

yes its been shipped, 1zv44a280341004196 ups

was shipped on tuesday

[mv301]

Thank you!

[steveo]

u have to add piece of shrink tube or something over the stuffing tube as it changes to the teflon liner and enters the strut, if not water will travel up the shaft and into the boat, i did at first but it was so tight i could not adjust the strut , now that i think about only shrinking the ends of a long piece might be better than the whole thing to allow movement

[steveo]

or u could install a piece of silicon tubing to the stuffing tube inside the boat over the flex shaft, i forgot about that one