ESCs, props, motor, flex, liposack

[BHChieftain]

Hi,
I have a few items available. Anything over $50 I'll include CONUS shipping, else shipping is not included.
I offer a 2 week money back guarantee on all items, but buyer needs to pay return shipping.

Used Swordfish HV240A ESC, waterproofed with gasket sealer. Has 8mm bullets on it. Includes programming card, instructions, and CD: $150. I have not personally run this ESC but my boating buddy says it works great-- he ran it with a Miss Geico on 5S1P... (SOLD)

Used Seaking 90A ESC with about 6 runs on it. Has 6mm bullets on battery side and 5.5mm bullets on motor side. I cooked one of the caps as my leads were too long... it'll run about 30 seconds before shutting off. Has been waterproofed with spray on electrical tape. Needs at least 1 new cap. $25

Used Traxxas RX, 4 channel, 27MHz AM, with TX crystal: $5

New spektrum S200 servo: $10

New Original Lipo Sack, 9"x12", velcro seal: $10

Used .150 flex drive with 3/16 prop shaft. It is 12.75" long. Good shape. $10 (SOLD)

Used Tenshock motor with water cooler. Not sure of KV, but is marked "1530" on it, I think it is in the 3400-3800KV range. Comes with a water jacket. I had this motor as part of a used tenshock mono1 boat I purchased, and the boat did not run well-- I am not sure if the problem was with the ESC or if this motor was demagnitized (I replaced both componets and did not bother isolating the problem). So, this motor is either fried or works great. It turns smooth and has no external damage... but buyer beware... $10. (SOLD)

PROPS:

X637, sharpened, balanced, and very nicely thinned. $30

M445, sharpened and balanced $30 (SOLD)

X440, sharpened and balanced $25


Please keep all traffic in the thread.

Thanks,
Chief

[LOVE6S]

what do you have to get to ship the 445?

[lenny]

Hi,
Do you no the most volts that where used on the HV Esc,
And how much run time on it ?
It is good from 3s to 12s right ?

[Alexgar]

Cheif what's the shaft size on the 1530

[BHChieftain]

what do you have to get to ship the 445?

If you buy something else in combination with the m445 I'll cover the shipping. Else CONUS shipping is extra (usually ~$5)

Chief

[LOVE6S]

If you buy something else in combination with the m445 I'll cover the shipping. Else CONUS shipping is extra (usually ~$5)

Chief

ok I will take the flex and the 445, yhat should fit a bj 26 tube, do you know?

[BHChieftain]

Hi,
Do you no the most volts that where used on the HV Esc,
And how much run time on it ?
It is good from 3s to 12s right ?

Here's a link to the manual:

https://astecmodels.co.uk/pdfs/hifei/Swordfish%20HV%20240A%20ESC%20Manuals.pdf

States this ESC is good up to 12S

My friend bought it for his Miss Geico, only ran it on 5S1P for just a few months. He did not like the Geico and moved on to other boats.

Chief

[BHChieftain]

Cheif what's the shaft size on the 1530

Hi Alexgar,
Shaft size is 4mm. Hey, did the tenshock ESC I sold to you a while back work ok? I gave you the same disclaimer that I was not sure which component was working... that was the ESC that came with this motor...

Chief

[lenny]

Ok thanks for the link,

Does it work RIGHT?
Has it ever been wet?
ANY smell of 'burn' to it?

[BHChieftain]

ok I will take the flex and the 445, yhat should fit a bj 26 tube, do you know?

Not sure... the .150 will fit in either in a 1/4" tube with a teflon liner, or a 7/32" without a liner.

Paypal ID is: [email protected]

Chief

[BHChieftain]

Ok thanks for the link,

Does it work RIGHT?
Has it ever been wet?
ANY smell of 'burn' to it?

Hi,
According to my buddy, it works. I have seen him run it on his Miss Geico several times. I have also seen him flip his boat, and I have seen him run it again the following week without any problems (I don't actually know if the ESC was wet, but we should assume so). No burn smell. Remember, it comes with a 2 week money back guarantee so you can check it out-- if CONUS, I'll pay for the outbound shipping and if you want to return it you pay return shipping. I would be suprised if there was any issues with it, but I cannot personally vouch for it since it I have not run it...

Chief

[Emdev2]

Is the 240 ESC the pro version or the older one? What color is the label? Will you take $125 shipped?

[Alexgar]

Chief it ran a full run on a 8xl in a mean machine on a x442 but I also added a large capacitor

[BHChieftain]

Is the 240 ESC the pro version or the older one? What color is the label? Will you take $125 shipped?

Hi,
It is the older version-- the label has been peeled off.

I'm gonna hold at $150 for now, but if no bites might come back to you...

Chief

[Brushless55]

Hi,
According to my buddy, it works. I have seen him run it on his Miss Geico several times. I have also seen him flip his boat, and I have seen him run it again the following week without any problems (I don't actually know if the ESC was wet, but we should assume so). No burn smell. Remember, it comes with a 2 week money back guarantee so you can check it out-- if CONUS, I'll pay for the outbound shipping and if you want to return it you pay return shipping. I would be suprised if there was any issues with it, but I cannot personally vouch for it since it I have not run it...

Chief

Dang James!
you are the man.. great reason right there for anyone to buy this esc