Bulletproof 4S/6S Traxxas Spartan

[airman66285]

I am selling my modified Traxxas Spartan. I modified this boat to run either 4S or 6S and it performs equally well in both power configurations. I have added the following aftermarket parts:
-Seawing 180 ESC with 6 additional filter capacitors
-Leopard 4082 2200kV motor with water cooling jacket (exactly 4 runs on 4S)
-Keda 4074 1350kV motor with water cooling jacket for 6S runs
-Kintec Racing rudder with dual water pickups
-Jeff Wohlt 3/16" (.187) flex shaft and stuffing tube
-Octura x642 propeller
-Oversized cooling lines throughout
-Fiberglass reinforced canopy and (2) 316 S.S. canopy bolts
-(4) Traxxas trim tab adjusters
Also included in this sale are (2) Zippy Flightmax 5000mah 45C 4S batteries that only have a single run on them. Cell number 2 on pack number one reads low at 4.0v while all the other cells read exactly 4.20 volts when fully balanced charged.

I am asking $350.00 (USD) plus shipping. Please post all questions here in the forum, no PM's please.
SOLD

[airman66285]

More pictures:P1010350.JPGP1010351.JPGP1010357.JPGP1010358.JPG

[airman66285]

And a few more pictures:P1010352.JPGP1010353.JPGP1010354.JPGP1010356.JPG

[RC-FOOL]

Would you be willing to sell items separate?

[airman66285]

I am not willing to separate at this time.

[RC-FOOL]

Ok i will just have to see how tonight goes i might just take the while thing

Does it come with a tx/rx?

[airman66285]

Ok i will just have to see how tonight goes i might just take the while thing

Does it come with a tx/rx?

It does not come with a tx/rx.

[RC-FOOL]

That's ok ill get back to you later tonight

[airman66285]

I forgot to mention that I modified the stuffing tube to outdrive bracket transition so that it does not auger the grease out at all. 6.5mm bullet connectors on the ESC and motors and 5.5mm bullet connectors and the battery side of the ESC. I also installed an Octura 5mm to .187 3 piece coupler as well. Very solid setup!

[tomstoys2]

If RC-Fool doesn't take it I am interest. What would shipping cost to zip 14502?
Thanks,
Tom

[airman66285]

If RC-Fool doesn't take it I am interest. What would shipping cost to zip 14502?
Thanks,
Tom

My zip code is 55445. The box would be 13" x 13" x 45" long and would weigh 20 pounds.

[tomstoys2]

Thanks!

[tomstoys2]

shipping cost acceptable.
Tom

[Boosted2000si]

That is a hell of a setup and a smoking deal.

Any details on the stuffing mod? Just the different shaft and tube?

If you part Id be interested in the ESC.

[airman66285]

That is a hell of a setup and a smoking deal.

Any details on the stuffing mod? Just the different shaft and tube?

If you part Id be interested in the ESC.

Regarding the stuffing mod, I used a new larger size brass tube and conformally epoxied it to the transom to make it water tight. I then placed a compression grommet between the stuffing tube and the outdrive. I also plugged the grease hole in the side of the outdrive to keep the grease in the drive. It works fabulously and the grease stays put.